Jaypro Sports PB-15 User Manual

JAYPRO SPORTS

15’ PLAYER’S BENCH, PB-15

LIST OF MATERIALS

PIECE #

PART # DESCRIPTION QTY.
1 AR5043 SEAT PLANK 15’ 1
2 PB751 BENCH LEG 3
3 HN5046 5/16” FLANGE NUT 6
4 EP0018 2” x 2” END PLUG 12
5 HB5030 5/16”-18 x 3” CARRIAGE BOLT 6
6 AR5044 HOLD DOWN CLIP 6
7 AR5045 END CAP 2
8 HS5035 #8 PAN HEAD SCREW x ½” 4

ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED: PHILLIPS SCREWDRIVER BIT W/ ELECTRIC DRILL (1),
½” SOCKET WRENCH OR ADJUSTABLE WRENCH (1)

1) SLIP THE END CAPS (7) SNUGLY ONTO EACH END OF THE PLANK (1).

USING THE ELECTRIC DRILL, ASSEMBLE A SELF-DRILLING SCREW (8)
THROUGH THE CAP AND INTO THE FLANGE OF THE PLANK. TWO
SCREWS ARE REQUIRED PER END CAP.

2) FOR EASIEST ASSEMBLY, POSITION SEAT PLANK (1) ON A LEVEL

RAISED SURFACE SUCH AS A DESK TOP, BLEACHER SEAT OR WORK
BENCH. PLACE THE CARRIAGE BOLT (5) AND BOLT CLIPS (6)
APPROXIMATELY INTO PLACE WITHIN THE SLOTS OF THE PLANK.
NOTE THAT THE LEGS SHOULD BE NO MORE THAN 8” FROM THE
PLANK EDGE.

3) POSITION THE LEGS AS SHOWN AND LOOSELY ASSEMBLE THE

HARDWARE ILLUSTRATED IN DETAIL ‘A-A’. DO NOT FULLY TIGHTEN
THE HARDWARE AT THIS TIME. LEVEL THE BENCH AND MAKE SURE
THE LEGS ARE ADEQUATELY SPACED APART. TIGHTEN ALL
FASTENERS FULLY.