![](/html/07/0787/0787b9ba3bd19f92a400ce682467cbb5c07c9d92825926ed08112bed87eadfbb/bg2.png)
JAYPRO SPORTS
FLOOR PLATE ASSEMBLY, FP-90
LIST OF MATERIALS
PIECE NO. PART NO. DESCRIPTION QTY.
1 FP-90 FLOOR PLATE ASSEMBLY 1
2 HS2726 HEX HEAD BOLT ½”-13 x 2 ½” 1
3 HN704 HEX NUT ½”-13 1
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED: Hammer Drill
1 3/8” Masonry Drill Bit
Mixing Container And Water
Small Vacuum Cleaner
Stiff Circular Brush (Bottle Brush)
Putty Knife Or Scraper
Rag Or Other Absorbent Material
Regular Power Drill
1 3/8” Wood Drill Bit
5/32” Drill Bit
Screwdriver With Wide Blade
¾ lb. (Approx) Non Shrink Anchoring Cement
NOTICE
The fp-90 floor plate assembly is manufactured with a removable center section which
can be replaced in the event that the internal threads are damaged. Upon original
installation of the floor plates or replacement of threaded sections, be sure that the
replacement threaded sections are installed very tightly using a thread locking sealant to
prevent easy removal or tampering.
PLEASE READ INSTRUCTIONS IN THEIR
ENTIRETY BEFORE BEGINNING INSTALLATION
1) Locate and mark the center locations of the floor plates using the layout diagram in
the equipment instructions sheet. Re-check all center locations for accuracy before
installing the floor plates.
2) Using the 1 3/8” wood drill bit, drill a hole in the wood floor and the wood sub floor
down to the concrete base as shown in figure ‘a’.
3) Screw the ½” bolt with the nut into the bottom of the floor plate. Adjust the bolts so
it will reach ½” x ¼” from the bottom of the hole when the floor plate is in place.
Tighten the nut against the floor plate bottom to lock the bolt into place. In some
cases the bolt supplied with the fp-90 unit will not reach to the bottom of the hole in
the cement. If this happens, a longer bolt or threaded rod should be used to insure
reaching the bottom.
4) Next, completely remove the dust
compressor, or battery filler.
5) Fill the hole with water. Scrub the sides and bottom with a stiff brush, such as a
bottlebrush. This is very important
from the hole by using a vacuum cleaner, air
.