JayBird BBX1 User Manual

Download

Page 1

USER GUIDE

BLUEBUDS X PREMIUM BLUETOOTH EARBUDS (BBX1)

QUICK FIND

SETUP

UNDER-EAR SETUP AND SOUND CHECK OVER-EAR SETUP

DETAILED INSTRUCTION

IN-THE-BOX CHARGING & BATTERY STATUS PAIRING COMMANDS SPECS & WARRANTY

...........................................................................................................29

............................................................................................12

.....................................................................................................27

.......................................................................27

......................................................................................................33

........................................................................................34

..........................................................2

UNDER

INSIDE THE ACCESSORIES PACKET

L M S CORD CLIPS

(FOR LATER)

GREAT SOUND PERFORMANCE IS IN SELECTING THE RIGHT SIZE EARTIP

WE LOVE GREAT SOUND. MAKE SURE YOU HEAR IT.

Because everyone’s ears are different, be sure to try all sizes of eartips. Only with the right size eartips will you enjoy a snug fit & premium sound quality.

BACK IT UP WITH SECURE FIT EAR CUSHIONS.

The earbuds may slip out of your ear a little. You will lose bass when this happens so use the secure fit ear cushions to hold them in place for best sound.

BEGIN WITH THE TRADITIONAL

UNDER-EAR FIT OPTION

TO DETERMINE YOUR SIZES

L&R ORIENTATION

NOTE EARTIPS ANGLE INWARDS (FORWARDS)

FOLLOWING DIRECTION OF YOUR EAR CANAL.

This means that L&R orientation is

reversed for over-ear, as explained later.

WHEN WORN UNDER-EAR:

CONTROLLER ON

RIGHT side

SOUND CHECK

Pair (set up) headphones to your music device, play music, and try each size of eartip to find the best fit and sound performance.

A proper seal is essential for you to fully appreciate the high quality audio of BlueBuds X.

NEED HELP PAIRING?

Full pairing details pages 29-32.

HOLD 4 SEC TO PAIR

ALTERNATING RED/GREEN

VOICE PROMPT: “SEARCHING ...”

UNDER

SECURE FIT

INSTALL YOUR PREFERRED SIZED SECURE FIT EAR CUSHIONS AS SHOWN. FITTING / SIZE SELECTION

GUIDANCE ON NEXT TWO PAGES.

LOCK THE TIP OF THE EAR

CUSHION INTO THE TOP OF THE

BOWL OF THE EAR AS SHOWN.

YOU SHOULD HAVE A SNUG FIT

CONTROLLER

RIGHT

EAR

UNDER-EAR:

WITH CONTACT ON THE LOWER,

BACK AND TOP PORTIONS OF

THE BOWL OF THE EAR.

SLIDE SECURE FIT EAR CUSHIONS ALL THE WAY BACK AND COVER LED

(DON’T WORRY, LED GLOWS CLEARLY THROUGH THE EAR CUSHION)

ENJOY

OVER

NOW THAT YOU KNOW YOUR PREFERRED EAR TIP & CUSHION...

and have a sense of the audio performance without other distractions, you are ready for over-ear fitting.

REMOVE THE SECURE FIT EAR CUSHIONS. YOU WILL INSTALL THEM DIFFERENTLY THIS TIME.

ADVANCED

OVER-EAR FIT OPTION

FURTHER TO THE MENTION ON THE BOX...

OVER-EAR FIT IS DEDICATED TO MUSIC, NOT DESIGNED FOR CALLS.

IT LIBERATES SPORTS MUSIC LISTENING BY LIFTING THE CORD OFF THE NECK,

AND SHIFTS THE MIC BEHIND THE EAR.

SOME ADJUSTMENT TIME IS NEEDED WHEN SWITCHING BETWEEN FIT OPTIONS.

Your ear canal travels up and forward. The intelligent patent pending BlueBuds X angles to the same direction in either wearing style, encouraging a great, snug fit.

L&R ORIENTATION

NOTE EARTIPS ANGLE INWARDS (FORWARDS) & UPWARDS,

OVER

FOLLOWING THE DIRECTION OF YOUR EAR CANAL.

WHEN WORN OVER-EAR:

CONTROLLER ON

LEFT side

CORD MANAGEMENT CLIPS

Over-ear mode requires less cord, so before fitting, install the cord management clips to secure the slack for a customized fit.

OVER

MAKE AN “S” SHAPE WITH THE MIDDLE SECTION OF THE CORD

SECURE FIT

TAKE YOUR PREFERRED SIZED SECURE FIT EAR CUSHION AND INSTALL IN REVERSE DIRECTION

INSERT CORD INTO 2 OF THE 3 SLOTS IN EACH CLIP AS SHOWN OMITTING THE FINAL ROUNDED SLOTS.

WITH POINTED END NEXT TO CORD.

IMPORTANT: Check your size preference in under-ear

mode first as it can be difficult to tell in over-ear mode, and may be different to other JayBird products.

See next steps.

OVER

- PUT THE HEADPHONES ON, USING INDEX FINGER TO PUSH TIP OF EAR CUSHION INTO PLACE TO SECURE EARBUDS (A MIRROR HELPS FIRST TIME).

- WITH EARBUDS SECURED, ADJUST POSITION OF CORD MANAGERS (PULLING TOO TIGHT WILL OF COURSE DISLODGE EARBUDS, KEEP A LITTLE SLACK).

CONTROLLER

OVER

LEFT

EAR

ENJOY

TAKE OFF HEADPHONES, INSERT CORD INTO THE FINAL ROUNDED SLOTS, PUT HEADPHONES BACK ON, NOW YOU ARE READY TO GO!

DETAILED INSTRUCTIONS

IN THE BOX

BlueBuds X Bluetooth Headphones JayBird Carry Case 3 pairs eartips (S,M,L) 3 pairs ear cushions (S,M,L) 2 cord management clips USB Cable User Manual

PAIRING (SETTING UP) HEADPHONES WITH YOUR PHONE / MUSIC DEVICE

1. With headphones turned off, & within 1 meter (3 feet) of music device, press & hold center key for more than 4 seconds until you see alternating red/green flashing of the status indicator and a voice prompt saying “Searching for your music device”.

2. On your phone/music device, turn Bluetooth on & have it search for Bluetooth devices (see instructions in the phone/music device manual for details).

3. Check for “BlueBuds X” and select (enter passcode 0000 if prompted).

4. BlueBuds X voice prompt will say “headphones connected”.

5. If the pairing is not successful, switch off headphones by pushing the center key for more than 4 seconds and repeat the steps outlined above.

PAIRING WITH A BLUETOOTH ADAPTER

1. Place headphones and mobile phone within 1 meter (3 feet) of each other.

2. Put the headphones into pair mode as outlined on prior page.

3. If using BAU Universal Bluetooth Adapter put into pair mode also (see BAU manual).

4. Plug the Bluetooth adapter into the music device and play a song.

5. The headphones and adapter will pair automatically (passcode of adapter must be 0000).

6. After successful pairing and connecting, the headphones will say “Headphones connected”.

CHARGING

Charging the battery before use is recommended but not required. BlueBuds X ships pre-charged however initial charge will vary.

Look for this Bluetooth headset battery status icon top right corner of your iPhone screen to see status of BlueBuds X battery.

VOICE PROMPT “BATTERY LOW”

Approx 15 mins prior to empty

MICRO USB CHARGING

Locate fingernail recess and remove back cover to expose micro USB charge point. 2+ hrs for full charge gives 8 hours of playtime. 30 mins charging gives 90 minutes of play time.

PAIR MODE: LED ALTERNATES RED/GREEN

HOLD 4 SEC TO PAIR

PAIRING WITH SEVERAL BLUETOOTH DEVICES

Paired devices will remember each other unless pairing information is deleted, so there is no need to pair again. BlueBuds X can pair and remember 8 phone/music devices. Repeat the steps outlined on prior pages to set-up your headphones with another phone/music device. Note that if a 9th phone/music devices is paired the oldest pairing information is deleted. BlueBuds X will connect with the latest connected device. If you want to use another paired phone/music device, switch off the Bluetooth function of the current Bluetooth device, and then connect it with the other phone/music device by selecting “BlueBuds X” in the Bluetooth device list and press connect. Turn the originally paired device back on to reconnect and switch between either of the devices.

VOICE PROMPT:

When you hear “Power on” continue pushing until you hear

“SEARCHING FOR YOUR MUSIC DEVICE ...”

LED STATUS

Red: Charging Green (with USB cable connected): Charged Red+Green Alternating: Pair Mode No Light: Standby / Play Mode / Powered Off

ARE HEADPHONES ON? IS BATTERY LOW?

In Standby* mode, push + or -, watch LED: Green = Powered on and well charged Red = Low battery No Light = Powered off

* Standby Mode:

Powered on but not connected to any device

COMMANDS

WARRANTY, CARE & MAINTANCE

Full warranty, care and maintenance details at jaybirdgear.com/warranty +1.866.244.3399

WARNING: Due to the isolating characteristics of these headphones do not use while driving, riding a bike or where vehicular trafﬁc is present, or in any other activity where failure to hear surrounding sounds could be dangerous. Use of these headphones at excessive volumes may cause permanent hearing damage. Always turn the volume down before use. Take caution in regards to inserting objects into ear canal, use at own risk.

Copyright 2012 JayBird, LLC. All rights reserved. JayBird, and the JayBird logo are trademarks of JayBird, LLC. Bluetooth is a trademark owned by Bluetooth SIG, Inc. USA, and licensed to JayBird, LLC. iPhone is a trademark of Apple, Inc., registered in the U.S. and other countries. Manufactured under European patent no EP1410607B1 & corresponding foreign patents

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications to device will void the user’s authority to operate the device. The battery is recycled. Do not dispose of the battery in fire, as it may cause explosion.

PUSH 1 SEC PUSH 4 SEC PUSH

Add’l Center Button Call Commands

Answer 2nd call, end call

Reject 1st/2nd call, switch

OFF

Mute & unmute call: push + & Switch active call to BlueBuds X: push -

between 2 calls, voice dial Redial

Assembled in China.

SPECIFICATIONS

Bluetooth Version V2.1 + EDR (newer versions offer no benefits for headphones) SBC codec Customised SBC codec offers high fidelity without needing APT-X Profile Handsfree v1.6, Headset v1.1, A2DP v1.2 and AVRCP v1.4 Effective Range 10 meters (30 feet) Working time Music & calls up to 8 hours Standy time Up to 250 hours Input voltage DC 5V 100mA Charging time Approximately 2 hours Dimensions 23 x 13 mm earbud size, 540 mm cord length Weight Approx 13 g

TAKE A MOMENT TO REGISTER YOUR

LIFETIME WARRANTY AGAINST SWEAT

jaybirdgear.com/intheclubnow

LISTEN RESPONSIBLY

Avoid excessive volume levels

and prolonged periods of listening.

Do not use around road traffic.

HAVE FUN