JayBird BBX1 User Manual

USER GUIDE

FCC ID:XX8BBX1

BLUEBUDS X PREMIUM BLUETOOTH EARBUDS (BBX1)

IN THE BOX

BlueBuds X Bluetooth Headphones JayBird Carry Case 3 pairs eartips (S,M,L)

CHARGING

Charging the battery before use is recommended but not required. BlueBuds X ships pre-charged

however initial charge will vary. 3 pairs ear cushions (S,M,L) 2 cord management clips USB Cable User Manual

Look for this Bluetooth headset battery status

icon top right corner of your iPhone screen to

see status of BlueBuds X battery.

PAIRING (SETTING UP) HEADPHONES WITH YOUR PHONE / MUSIC DEVICE

1. With headphones turned off, & within 1 meter (3 feet) of music device, press & hold center key for more than 4 seconds until you see alternating red/green flashing of the status indicator and a voice prompt saying “Searching for your music device”.

2. On your phone/music device, turn Bluetooth on & have it search for Bluetooth devices (see instructions in the phone/music device manual for details).

3. Check for “BlueBuds X” and select (enter passcode 0000 if prompted).

4. BlueBuds X voice prompt will say “headphones connected”.

5. If the pairing is not successful, switch off headphones by pushing the center key for more than 4 seconds and repeat the steps outlined above.

PAIRING WITH A BLUETOOTH ADAPTER

1. Place headphones and mobile phone within 1 meter (3 feet) of each other.

2. Put the headphones into pair mode as outlined on prior page.

3. If using BAU Universal Bluetooth Adapter put into pair mode also (see BAU manual).

4. Plug the Bluetooth adapter into the music device and play a song.

5. The headphones and adapter will pair automatically (passcode of adapter must be 0000).

6. After successful pairing and connecting, the headphones will say “Headphones connected”.

VOICE PROMPT “BATTERY LOW”

Repeated regularly 15 mins prior to empty

MICRO USB CHARGING

Locate fingernail recess and remove back cover to expose micro USB charge point. 2+ hrs for full charge gives 8 hours of playtime. 30 mins charging gives 90 minutes of play time.

LED STATUS

Red: Charging Green (with USB cable connected): Charged Red+Green Alternating: Pair Mode No Light: Standby / Play Mode / Powered Off

ARE HEADPHONES ON? IS BATTERY LOW?

In Standby* mode, push + or -, watch LED: Green = Powered on and well charged Red = Low battery No Light = Powered off

* Standby Mode:

Powered on but not connected to any device

PAIR MODE: LED ALTERNATES RED/GREEN

HOLD 4 SEC TO PAIR

VOICE PROMPT:

When you hear “Power on” continue pushing until you hear

“SEARCHING FOR YOUR MUSIC DEVICE ...”

PAIRING WITH SEVERAL BLUETOOTH DEVICES

Paired devices will remember each other unless pairing information is deleted, so there is no need to pair again. BlueBuds X can pair and remember 8 phone/music devices. Repeat the steps outlined on prior pages to set-up your headphones with another phone/music device. Note that if a 9th phone/music devices is paired the oldest pairing information is deleted. BlueBuds X will connect with the latest connected device. If you want to use another paired phone/music device, switch off the Bluetooth function of the current Bluetooth device, and then connect it with the other phone/music device by selecting “BlueBuds X” in the Bluetooth device list and press connect. Turn the originally paired device back on to reconnect and switch between either of the devices.

COMMANDS

PUSH 1 SEC PUSH 4 SEC PUSH

Add’l Center Button Call Commands

Answer 2nd call, end call

OFF

Reject 1st/2nd call, switch between 2 calls, voice dial Redial

Mute & unmute call: push + & Switch active call to BlueBuds X: push -

WARRANTY, CARE & MAINTANCE

Full warranty, care and maintenance details at jaybirdgear.com/warranty +1.866.244.3399

WARNING: Due to the isolating characteristics of these headphones do not use while driving, riding a bike or where vehicular trafﬁc is present, or in any other activity where failure to hear surrounding sounds could be dangerous. Use of these headphones at excessive volumes may cause permanent hearing damage. Always turn the volume down before use. Take caution in regards to inserting objects into ear canal, use at own risk.

Copyright 2012 JayBird, LLC. All rights reserved. JayBird, and the JayBird logo are trademarks of JayBird, LLC. Bluetooth is a trademark owned by Bluetooth SIG, Inc. USA, and licensed to JayBird, LLC. iPhone is a trademark of Apple, Inc., registered in the U.S. and other countries. Manufactured under European patent no EP1410607B1 & corresponding foreign patents

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications to device will void the user’s authority to operate the device. The battery is recycled. Do not dispose of the battery in fire, as it may cause explosion.

Assembled in China.

SPECIFICATIONS

Bluetooth Version V2.1 + EDR (newer versions offer no benefits for headphones) SBC codec Customised SBC codec offers high fidelity without needing APT-X Profile Handsfree v1.6, Headset v1.1, A2DP v1.2 and AVRCP v1.4 Effective Range 10 meters (30 feet) Working time Music & calls up to 8 hours Standy time Up to 250 hours Input voltage DC 5V 100mA Charging time Approximately 2 hours Dimensions 23 x 13 mm earbud size, 540 mm cord length Weight Approx 13 g

TAKE A MOMENT TO REGISTER YOUR

LIFETIME WARRANTY AGAINST SWEAT

jaybirdgear.com/intheclubnow

LISTEN RESPONSIBLY

Avoid excessive volume levels

and prolonged periods of listening.

Do not use around road traffic.

HAVE FUN