Jastec JTBT2100 User Manual
von-STD Manual Instruction
Cautions For Safety
1. This product into water or prolonged exposure to moisture can cause failure resulting in no charge for broken A/S
11. Products by shock or vibration of the vehicle is released from the car because it can cause data loss if the installation
st
atus checks
We kindly recommend you to be fully aware of using a product accurately and for safety of user. All liabilities by
uncomplying cautions are not supposed to be responsible to manufacturer.
.
2. Do not disassemble or repair this product if the label seal is broken or damaged, free A/S will not be received.
3. Do not separate or equip OBD II module while driving vehicle or ignition off. – This causes to car accident and defective of it.
4. Please note that on the surface of the product carefully to avoid strong detergent or chemicals.
5. This product works under the proper temperature -30~+80℃.
6. Do not impact the product. It’s the cause of product defective.
7. Using other products rated voltage is the cause of the crush. Rated voltage state must be sure to use the product.
8. After parking vehicle in a safe place, install OBD II module then drive.
9. When installing or removing product on the vehicle as the vehicle peripheral device could be due to injury, Please be careful.
10. Incorrect installation of the product by the vehicle’s shock and vibration and can cause data loss, after the installation, please check
it properly.
on a regular basis. This product is equipped with a breakdown of the car by the impact of accidents, damage, of driving record, we are
not responsible for missing.
12. Jastec Co.,Ltd provides cable, please use the original cable.
2
This confidential information is not supposed to disclosed and misused to the third party
1. von-STD Descriptions
V
STD
ECU(Elect
it)
1.1 Overview
on-
By OBD standard protocol communication and can be saved a driving logs by connecting to PC.
3
as vehicle driving logs tracker designed to collect a vehicle driving information from
This confidential information is not supposed to disclosed and misused to the third party
ronic Control Un
1. von-STD Descriptions
Fi
t
pg
pg
b
d
datai
l
ti
d
tominimi
1.2 Specifications
In-vehicle Protocol
32 bit main processor Boasting fast and stable performance ARMv7 Cortex-M3 CPU has adopted.
Stability real-time operating system
USB communication USB Full-Speed (12Mbps) high data transmitter function supported.
Low power consumption and saving
rmware update suppor
Mass storage space
Data communication
Smart design
ISO 9141-2, ISO 14230-4(KWP-2000), ISO15765-4(CAN) J1850(PVM/VPW) protocol supported,
physical communication standard followed and high credibility being with vehicle DB.
System,hardware,applications,databases,data communications and other resources efficiently and
reliably manages the real-time operating system is used based on Tiny.
Standby power consumption in driving conditions with low start-off when the vehicle’s powersaving features built in to prevent battery discharge.
Firmware and vehicle DBprogram to communicate with a PC via USB connection to upgrade is
easy and fast..
Large amounts of information and operating data in real time on a high-capacity memory and
high data reliability by applying non-volatile memory can be saved.
High-speed communications, the processor transfer, processing speed andlargememorycapacity
ycombiningfeatures suchas vehicledriving recor
Due to small and light for easy installation and occupies less space, it doesn’t interfere with the
operation easier you can determine.
nrea
me an
zethe error.
4
This confidential information is not supposed to disclosed and misused to the third party
1. von-STD Descriptions
1.3 Functions
Drivinginf
d
USB
t
itt
Self diagnostic
pp g
ggpg
()
Saving vehicle information.
Collecting and saving driving logs information.
Driving logs record
Vehicle identification information / module certification / module serial number information / driving
data starting time and ending time / ignition On and Off time /
Accumulated driving distance / module connection and disconnection time / driving information
transmitting time / acceleration pedal or throttle valve open angle
Module operating check and alarm
Driving information security
ormation uploa
Power saving function
Firmware upgrade support
5
This confidential information is not supposed to disclosed and misused to the third party
Display [indicator] : power display lamp[POWER –blue] / status display lamp[STATUS -red]
Encoded saving data to not modify a driving recorded information.
ransm
Automatically power will be off when ignition off.
Supportingself diagnostic function throughOBDIImoduleoperatingcheck(Indicator).
Supporting firmware upgrade
er preferred.
Loading...