Jasco UCL44 User Manual

Length

2.56 in (65mm)

Width

1.30 in (33mm)

Height

0.39 in (10mm)

Channels

Operating Frequency

433.92 MHz

Power Supply

1 pcs “3V” Li-ion Battery

Buttons

Function

On/Off

Power on/off (Long press to pair learning)

favorite

Learning save function: Long press to save the current mode

bright select+

Brightness+ in white mode

bright select-

Brightness- in white mode

white select

Six white modes: 2000-2700-3000-4000-5000-6000K (Long press to cancel the pairing)

Modes Fade

Gradient Sync

Strobe

Jump Sync

Twinkle

Random colors changing every 1second, 0~100%,

User Manual

MODEL: UCL/44

Specifications

Buttons

Remote control has a total of 7 buttons, as shown below, including “ on/off, favorite, modes, color select, bright select+, bright select-, white select. According to the needs of the receiver equipment, it will be convenience to use for users.

Use Instructions

Adjacent bulbs do not appear of the same color at the same time Random colors fade in and out, Fade 10 seconds

Rainbow fade

between colors, Adjacent bulbs do not appear of the

same color at the same time Christmas Red Green White Saint Patricks Day Dark Green, Light Green, White 4th of July Red Blue White Fall Orange, Light orange, Dark yellow

Spring

Pastels (6 soft colors) Order: Purple, green, light

purple, white, yellow, green Rainbow Every bulb different color

Color select 15 colors

FCC Information

FCC ID: QOB-UCL44

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

·Reorient or relocate the receiving antenna.

·Increase the separation between the equipment and receiver.

·Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation.

NOTICE: Any changes or modifications to this product will void the user’s authority to operate the equipment.