Jasco GE 19209 User Manual

GE Model 19209

www.jascoproducts.com

Wireless Door Chime Kit

Installation Instructions for Battery Operated
Wireless Door Chime Kit

Required Tools: Small flat blade screwdriver, drill, drill bit, and phillips
screwdriver.

Included Hardware:

(2) Plastic screw anchors
(2) 4x20mm screws (for anchors)
(2) 3x20mm screws
(2) Double sided adhesive pads

The wireless door chime Kit has two components:

Chime (receiver) Push-Button (Transmitter).

Chime Tune Setting

All wireless chimes may have more than one push button. The chime tune for
each push button is set with jumpers 7-9.

Single Push Button Kit: If you purchased a kit with a single push button, the
chime tune will be set to Ding Dong from the factory.
Dual Push Button Kit: If you purchased a kit with two push buttons, one push
button will be set to Ding Dong and the other push button will be set to
Westminster from the factory.
The following instructions explain how to change the tune on any wireless push

button.

1. Remove the battery from the push button transmitter.

2. Locate the 9 position jumper shown below.

9 position jumper (This pushbutton is set for Ding Dong Chime since 7=off, 8=on,
and 9=off.)

3. Select the desired chime sound from the table below.

Chime Sound Table
Position 7 8 9

Westminster ON OFF OFF
Ding Dong OFF ON OFF
Knock OFF OFF ON
Bronze Chime ON ON OFF
Cuckoo Clock ON OFF ON
Foghorn OFF ON ON
Gong ON ON ON

ON: Add a jumper to a location
OFF: Remove jumper from a location.

4. Remove or add the jumpers to match the table.

5. Store unused jumpers as shown in the picture.

Parking the jumper on an open set of pins. The two jumpers on the left are in the
parked position.

Setting The House Security Code

Each chime component has jumpers for setting the house security code.
In most cases you will not need to change the factory settings for the
security code. If your chime activates intermittently or does not work at all,
you may be able to solve the problem by changing your security code.