Jasco 86597 User Manual

Thank you for purchasing the Wireless Phone Jack System.
Enclosed you will find:

1 - Base unit (two phone connectors on the right side)
1 - Extension unit (single phone connector on the right side)
1 - Six-foot phone cord
1 - Owner’s manual

EASY HOOK-UP

1. Plug the base unit (two phone connectors on right side) into an AC outlet; the
indicator light on the base unit will illuminate red. Next, connect the base unit to
an existing phone jack using six-foot phone cord (included); then connect the
phone to the unused connector on the base unit.

2. Plug the extension unit (single phone connector on right side) into an AC outlet

where connection is needed. The indicator light on the extension unit will blink
red. As soon as it recognizes the base unit, the indicator light will then illuminate
green; the indicator light on the base unit will also illuminate green, after it
recognizes the extension unit.

PLEASE READ THIS INFORMATION

Trouble Shooting
On Reverse Side

Wall Jack

Wall Outlet

Extension

Base Unit

Wall Outlet

Note:

• Do not plug base or extension unit into surge protectors, plug strips,

extension cords, other AC-power extension devices or GFCI-protected

outlets

• Phone connected to extension unit will not operate during a power failure

• Phone jacks can only be used for one phone line

• Follow installation procedure specifically as detailed in the owner’s manual

• If you lose dial tone or a phone connection, unplug and reset your units as detailed in the
Troubleshooting section on the next page

TROUBLE SHOOTING

Because you are using AC power lines for communication between units, you
may experience no dial tone or a rapid beeping at the extension unit. You may
also notice the indicator lights on your base and extension units remain solid
red. Should this occur, try the following steps:

1. Unplug extension unit from AC outlet. Find an AC outlet near installed base unit.

Unplug base unit, then plug it back into the same AC outlet. Next, plug
extesion unit into an AC outlet near base unit. Indicator lights on both units
should be green. If they remain solid red, refer to next step.

2. Press and hold button on right side of base

unit until the indicator light is solid red.

(Approximately five seconds.) Release the

button, then indicator light will blink orange.

This creates a new link code and places

base unit into program mode.

3. Press and release button on extension unit; indicator light will flash red, then turn

solid green.

4. Press and release button on base unit to take it out of program mode. The

indicator light will change from flashing orange to solid green.

5. Connect extension unit to desired device.

Again, this system uses AC power lines to communicate. Because of this, you

may encounter static, buzzing or humming at certain AC outlets. If the noise is
persistent, relocate the base and/or extension unit.

We are dedicated to quality customer service. If you experience unusual levels

of noise or the performance of the Wireless Phone Jack System does not

improve after following the above directions, DO NOT RETURN THE SYSTEM
TO THE STORE WHERE YOU PURCHASED IT; please call the Customer

Service Helpline at:

1-800-654-8483

Or visit our website at: www.jascoproducts.com.