Jasco 45144 User Manual

Keychain Transmitter Model : 45144

1. INTRODUCTION The transmitter allows you to operate the receiver. It is a keychain type transmitter to allow to access easily.

2. LEARN TRANSMITTER TO THE CONTROL PANEL In order for the transmitter to communicate with the control panel properly, the transmitter must be programmed to the control panel. Follow the brief instructions below or refer to the detail instructions from the User’s Instructions to program the transmitter to the control panel.

To program the transmitter to control panel:

1. Slide the mode switch to ‘ON” position in the control panel.

2. Press and hold the ‘Learn’ button in the control panel. The ‘ON’ LED will begin to flash and it will continuous beeps.

3. Press any one of the key on the transmitter.

4. If a connection has been made, you will hear a long tone from the control panel and the ‘ON’ LED will stop flashing.

3. OPERATION

Press the button for 1 second and release, this will activate the “learned” control panel.

4. BATTERY

The remote control operates on a 12-volt alkaline battery that is installed at the factory. Recommendation: Test your transmitter periodically to ensure that the battery is working.

5. WARRANTY

If, within one year from date of purchase, this product should become defective (except battery), due to faulty workmanship or materials, it will be repaired or replaced, without charge. Proof of purchase is required.

6. FCC

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

 Reorient or relocate the receiving antenna.  Increase the separation between the equipment and receiver.  Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.  Consult the dealer or an experienced radio/TV technician for help.

7. CUSTOMER SERVICE

If you would like to order Skylink’s products or have difficulty getting them to work, please :

1. visit our FAQ section at

2. email us at

3. call our toll free at 1-800-304-1187 from Monday to Friday, 9am to 5pm EST. Fax (800) 286-1320.

support@skylinkhome.com

support@skylinkhome.com, or

www.skylinkhome.com, or