Jasco 19200 User Manual

GE Model 19200

www.jascoproducts.com

Wireless Portable Chime

Installation Instructions for Wireless Portable
Door Chime Kit

Required Tools: Small flat blade screwdriver, drill, drill bit, and phillips

screwdriver.

Included Hardware:

(2) 3x20mm screws
(2) Double sided adhesive pads

The portable wireless door chime Kit has two components:

Portable Chime (receiver) Push-Button (Transmitter).

How To Install The Batteries

1. On the bottom of the portable chime you will find a round battery release
tab. Push the tab inward and slide the cover in the direction of the arrow.

The battery cover will slide off.

Battery Release Tab

2. Install 4 C-cell batteries (we recommend Alkaline Batteries)

3. Remove back of wireless push button and install the 12-volt battery
(included) as shown below.

Chime Tune Setting

All wireless chimes may have more than one push button. The chime tune for
each push button is set with jumpers 7-9.

Single Push Button Kit: If you purchased a kit with a single push button, the
chime tune will be set to Ding Dong from the factory.
Dual Push Button Kit: If you purchased a kit with two push buttons, one push
button will be set to Ding Dong and the other push button will be set to
Westminster from the factory.

The following instructions explain how to change the tune on any wireless push
button.

1. Remove the battery from the push button transmitter.

2. Locate the 9 position jumper shown below.

9 position jumper (This pushbutton is set for Ding Dong Chime since 7=off, 8=on,

and 9=off.)

3. Select the desired chime sound from the table below.

Chime Sound Table
Position 7 8 9

Westminster ON OFF OFF
Ding Dong OFF ON OFF
Knock OFF OFF ON
Bronze Chime ON ON OFF
Cuckoo Clock ON OFF ON
Foghorn OFF ON ON
Gong ON ON ON

ON: Add a jumper to a location
OFF: Remove jumper from a location.

4. Remove or add the jumpers to match the table.

5. Store unused jumpers as shown.

Parking the jumper on an open set of pins. The two jumpers on the left are in the
parked position.

Setting The House Security Code Setting

The House Security Code is pre-set at the factory and no further adjustment is
normally required. However, if you experience erratic or no operation from your
chime you may want to reset the House Security Code Setting.