Jasco 15306 User Manual

HEAVY DUTY

MECHANICAL TIME SWITCH

15306

24 HOUR TIME SWITCH

•

SWITCH: SPST CONTACT RATINGS: 40 AMP 120-277VAC 1000VA (120-277) PILOT DUTY 40 AMP TUNGSTEN 120VAC 120-277VAC SINGLE PHASE 20 AMP INDUCTIVE 2HP 120VAC; 5HP 240VAC

TIMING MOTOR: 120VAC 60Hz POWER CONSUMPTION: 3 WATTS MAX

For seperate motor terminals, remove bridge from terminals L & 1

Removable

Bridge

FOR 120 VAC

120VAC/60Hz

We recommend that installation be made by a licensed electrician. Disconnect power at main panel prior to installing or servicing this time switch or the equipment connected to it. Connect in accordance with national and local electrical codes. Supply Connections: Use gauge specied (AWG #8-14 ) suitable for 75ºC (167ºF). Replace insulator before turning on electricity to unit.

INSTALLATION AND OPERATING INSTRUCTIONS TO SET ON AND OFF TIMES: Light trippers turn ON.

Dark trippers turn OFF. Place tripper on dial edge as shown in gure and set point of each tripper to desired operating time. Note if selected time is AM

OFF TIME (Dark Tripper)

or PM. Hold tripper against dial edge and rmly tighten knurled screw.

INSTALLATION AND OPERATING INSTRUCTIONS TO SET DIAL TO TIME: Turn dial counter-clockwise until correct time is indicated by arrow on nameplate. FOR TEMPORARY MANUAL OVERRIDE: Press down lever on right of nameplate to turn ON. Press down lever on left of nameplate to turn OFF. CAUTION: Do not rotate dial for manual override. TO REMOVE MECHANISM FROM CASE: Press lever near case latch to release mainplate and swing the movement out. To replace, insert mainplate projections in slots opposite latch and swing movement in until it latches.

15306 MANUAL VERSION 1 12/15/09 WWW.JASCOPRODUCTS.COM

MANUAL

OFF

LEVER

Dial Calibrations

Knurled Screw

O F F

GE5360-41K2

E M I

O N

LOAD

ON TIME (Light Tripper)

MANUAL

LEVER

469D