James Loudspeaker SPL SERIES LCR User Manual

SPL SERIES LCR INSTALLATION GUIDE
(1 piece bracket)
Step 1 Unpack the carton. You should have 1 plasma/LCD/LED speaker bar, 2 brackets, 8 Allen screws and 4 aluminum holding tabs.
Step 2 Lay your TV face down on a pad or other
protected surface.
Step 3 Lay the speaker face down along the bottom of the TV. The bar should be the same length as the TV, so center the bar under the TV.
Step 4 Lay the 2 brackets down on the rear, lining up the slot in each bracket with the TV wall mount bracket holes on the rear of the TV.
Page 1
Step 5 Install the screws to hold the brackets to the TV but do not tighten them yet.
Step 6 Take one of the aluminum holding tabs and slide it under the speaker brackets top 2 screw holes. The thinner part of the tab should slide under the rear lip of the speaker.
Holding tabs will be black or silver
Step 7 Line up the 2 holes in the bracket with the 2 holes in the mounting tab and install 2 screws.
NOTE: Do not tighten these screws yet.
Page 2
Step 8 Slide another mounting tab under the bracket under the 2 lower mounting holes. The tab thinner portion of the tab should go under the lower rear lip of the speaker.
NOTE: In some installations, as was the case on this Samsung TV, one of the brackets covered one of the input terminals. So a speaker wire was connected before the bracket was screwed in place.
Step 9 Align the 2 lower holes in the bracket with the holes in the mounting tab and install 2 screws.
Step 10 Repeat steps 5 to 8 with the second bracket.
Page 3
Step 11 Now push the speaker up against the TV, make sure it is aligned to the left and right edges of the TV, and tighten the 8 mounting tab screws.
NOTE: At this point, with the 8 screws snug, the brackets should be captive to the speaker, but the speaker brackets and speaker should be free to slide up and down in their slots.
Step 12 You can now remove the screws holding the speaker brackets to the TV.
Step 13 Place the TV bracket on the TV, over the speaker brackets.
Step 14 Reinstall the screws into the TV bracket and tighten. The TV bracket and the speaker brackets should now be captive to the TV. NOTE
- Make sure to keep the speaker pushed up against the TV while tightening the bracket screws.
Step 15 Check the 8 screws on the speaker mounting tabs to ensure you have tightened them all.
Step 16 Hang the TV on the wall.
NOTE: We have not discussed when the speaker
wires should be attached this depends on the type of installation. We leave it up to you to make the choice of connecting the wires while installing the brackets or after.
Enjoy your new TV!
James Loudspeaker LLC
535 Airpark Road
Napa, CA 94558
Phone: +1.707.265.6343 Fax: +1.707.265.6334
www.jamesloudspeaker.com
Page 4
SPL-1pc-Rev B
Loading...