James ULTRA 2000 User Manual

ULTRA 2000

ULTRASONIC CLEANER

14/06/059-V3

USER GUIDE

INTRODUCTION

Use tap water. Special solutions are not necessary in most cases.

Principles of ultrasonic cleaning:

Millions of tiny air bubbles are generated within liquid by high frequency vibration. The air bubbles
burst when in contact with object and dislodge the debris to achieve the cleaning effect.

• Using tap water is sufcient. Puried water or distilled water has the same cleaning effect as

regular tap water for ultrasonic cleaning.

• When cleaning silver or copper items where oxidation has darkened the items, special
solutions such as SeaClean2, needs to be added to the water to remove the oxidation.

Read the Manual First

The Ultra range of ultrasonic cleaners are very easy to use, although to get the best from your new
purchase, we recommend you read this User Guide before getting down to any serious cleaning.
It also contains important safety information as well as practical hints.

UNPACKING

Remove your Ultra 2000 cleaner from its packaging and ensure that along with this User Guide you
have the correct mains plug tted for your supply and you have the specied accessories.

Retain the packing carton for storage of your unit, and also in the unlikely event that the unit needs to

be returned for service or repair.

TABLE OF CONTENTS

Safety Instructions ---------------------------------------------------------------------------------------------------- 2

Features and Accessories ------------------------------------------------------------------------------------------- 3

3 Level Cleaning Plan ------------------------------------------------------------------------------------------------ 4

Better Results --------------------------------------------------------------------------------------------------------- 5

What cannot be cleaned ------------------------------------------------------------------------------------------- 5

Operating Instructions ---------------------------------------------------------------------------------------------- 6

Different Ways of Cleaning ----------------------------------------------------------------------------------------- 7

Usage for Accessories ----------------------------------------------------------------------------------------------- 8

Maintenance and Storage ------------------------------------------------------------------------------------------- 9

Specication ----------------------------------------------------------------------------------------------------------- 9

1

2

SAFETY INSTRUCTIONS

Please read this before using your product

Do not attempt to remove any screws or panels.

There are no user serviceable parts inside.

Do not operate this unit if the cord or plug is damaged.
Please refer to a service centre for examination and repair.

To avoid electric shock, never touch the cord or socket with wet hands.

Never operate the unit when empty - damage may occur.
Keep the unit unplugged before lling.
Do not use boiling water as damage to the unit may occur.
Do not exceed the “MAX” marking on the inside of the tank.
Always unplug the unit immediately after use and before emptying the liquid.

Do not operate the unit next to heat sources such as radiators.

Operate on a dry level surface.

To avoid electric shock do not immerse the unit into water or other liquid. The
unit should not be exposed to dripping or splashing and no objects lled with

liquids should be placed on top of it.

Do not ll the tank with abrasives or corrosive chemicals. Never use acids,

solvents or alcohol as these are not suitable for use in this cleaner and will
invalidate the warranty.
Repeated cleaning cycles will enhance the cleaning effect.

Never leave the unit unattended when it is switched on.
Always unplug and clean the unit when left overnight.

Optional Accessory

Lid Viewing window

Plug and cord

On button

Off button

Watch

Stand

3

FEATURES AND ACCESSORIES

Operation LED

Housing

Stainless steel tank

Jewellery

Necklaces, rings, bracelets etc.

Porous stones such as pearls etc. should not be immersed. Use the optional
watch stand to hold the stones out of the water. If in doubt please refer to our
website: www.jamesproducts.co.uk for further details.

Watches and glasses / sunglasses

Waterproof wristwatches, watch chains,
glasses, sunglasses etc.

Watches should be fully waterproof (30m or more). For watches that are
not waterproof, the optional Watch Stand can be used. The coating on
some spectacle lenses can exhibit hairline cracking during ultrasonic cleaning.
If in doubt check with your optician before cleaning such items.

Toiletry items

Electric toothbrush heads, electric shaver heads,
razor blades, combs, toothbrushes, dentures etc.
Ensure that all items are waterproof and non-porous.

3 LEVEL CLEAN PLAN

4

Lightly stained items

Use warm water and a

few drops of washing
up liquid

1

General staining or
light tarnishing

Use warm water
(45-60°) and SeaClean2
Double Concentrate

2

Heavily stained or
tarnished metals

Use warm water
(45-60°) and add up to

50% more SeaClean2

3

Use the appropriate level for your items:

21

3

21

3

21

3

Any unrm or inlaid item may become loose. Items that are easy to be discoloured are
not recommended for ultrasonic cleaning. eg: textiles, leather products, woodware etc.

DO NOT put any objects that are porous (e.g. tortoiseshell or hawksbill spectacle frames)
or not waterproof (e.g. mobile phones) in the tank for cleaning as damage may occur.

BETTER RESULTS

5

Important tips for getting better results

• To start, ll the tank with warm tap water (ideally 45° to 50° C). Never boiling, but bearable to put
your hand into. You will always get better cleaning results with warm water and it will help the unit
to achieve maximum cleaning potential more quickly.

• Some items need added detergent for cleaning. We recommend 3 to 4 drops of regular washing up
liquid when cleaning objects such as spectacles and toiletry items.

• Do not overload or stack items. Remember whatever the water touches, it will clean.

• When cleaning spectacles, ensure that the lenses are free from any objects and are facing upwards.
As mentioned on the previous page, the coating on some spectacle lenses can exhibit hairline
cracking during ultrasonic cleaning. If in doubt, check with your optician or the manufacturer before
cleaning such items.

• Some spectacles are not suitable for ultrasonic cleaning because the frames are made from porous
materials. If you have any doubts, consult either the supplier of the spectacles or James Products
before placing them in the ultrasonic cleaner.

For more advice please refer to our website: www.jamesproducts.co.uk

WHAT CANNOT BE CLEANED

JEWELLERY

Hawksbill, Pearl, Emerald,
Ivory, Coral, Agate.

PRECIOUS METAL

Soldered metal, electro
plated metal, bindings

WATCHES

None waterproof watches

(Except 30m+ watches)

OTHERS

Wood, Glass, Contact lens,
Ceramic, Camera colored lter

Colour may change or brightness could be lost during

ultrasonic process.

Ultrasonic cleaning is not suitable for metal objects that

have been soldered as the tiny bubbles will dislodge any

unsolid soldering or bindings. Any cracked electro plating

will be enlarged after cleaning.

Water will get into the watch movement of none

waterproof watches.

Cracks in ceramic, wooden items, or laminated glasses

will be enlarged by ultrasonic cleaning. (It won’t happened

if the item is in perfect condition).

OPERATING INSTRUCTIONS

6

To avoid causing permanent damage:
Never operate the unit without water in the cleaning tank. Never use boiling water.

Open the lid and ll the stainless steel tank with warm water (ideally 45°

- 50°C). Do not exceed the “MAX” marking on the inside of the tank.

Place the item to be cleaned into the water. Ensure any items

with a delicate surface such as glasses/sunglasses lenses are

not touching or rubbing the tank walls or base.
Ensure the item is immerged as fully as possible, ensuring the
water level does not exceed the “MAX” marking.

Close the lid and ensure your hands are dry. Plug the supplied mains
cable into the unit and then into the nearest mains outlet.

Press the ON button to start cleaning. The red operation indicator
will illuminate while the unit is in operation. The built in timer will
automatically turn the cleaner off after 3 minutes.

Note: During operation the unit will “buzz”, this is normal.

If required, you can press the OFF button at any time to stop or pause
the cleaning process. Press the ON button again to resume cleaning and
continue the countdown. When cleaning has nished, you can press the

ON button again to repeat the process.

When cleaning is nished, unplug the unit from the mains and open the
lid to remove the item. Pour away the water and wipe the stainless steel
tank with a clean dry cloth.

1

2

3

4

5

6

7

Emptying the tank

• Remember to change the water between cycles as it becomes dirty.

• Always ensure the unit is unplugged when changing the water.

• Always pour liquid away via the front spout.

DIFFERENT WAYS OF CLEANING

General cleaning

Use plain warm tap water (ideally 45° to 50°C) with a few drops of
washing up liquid. Ensure that the water level does not exceed the “MAX”
marking when immersing the item.
If the item is very dir ty or has oil or grease smears (CDs, etc.) then add

3 to 4 drops of regular washing up liquid to enhance the cleaning result.

Enhanced cleaning

If the item is very dir ty or has oil or grease smears then add a drop or two

of standard washing up liquid into the water to enhance the cleaning result

or you can achieve amazing results by using our SeaClean2 concentrate.

Extensive cleaning

If the item to be cleaned needs extensive cleaning or sterilising, then use the
“Enhanced Cleaning” procedure rst, then replace with clean water and add
a drop or two of liquid soap (eg: hand wash soap) into the tank and repeat

the cleaning procedure.

Cleaning large items

If the item is too large to t completely in the tank, then you can use the
ultrasonic cleaner with the item partly immersed with the lid open. Ensure
that the “MAX” marking is not exceeded when immersing the item.

Removing tarnish, carbon and rust

When removing tarnish, carbon & rust from your non-plated (e.g.: solid silver) metals, it is
recommended to use a specialist cleaning solution such as SeaClean2 concentrate (see page 9 for
details) when using your ultrasonic cleaner, as ultrasonic cleaning alone may not achieve the results.
If in any doubt about your items to be cleaned, before use, contact your jeweller or James Products
for information and advice on cleaning your items.

Important notes

• Care should be taken when using different types of cleaning soaps or detergents. Always ensure
they are suitable for the item you are cleaning. If in doubt, please ask James Products or check
www.jamesproducts.co.uk.

• The use of SOLVENTS or ALCOHOL in the tank or on any part of the cleaner will damage your

ultrasonic cleaner and void any warranty.

USING THE ACCESSORIES

8

Watch stand (optional accessory)

Only watches that are fully waterproofed to a depth of 30 metres
or more should be immersed in the ultrasonic cleaner tank.
If your watch is not suitable to be fully immersed, you can use a
watch stand to ensure that only the strap makes contact with the
uid.
Earrings and other jewellery items which should not be immersed
for ultrasonic cleaning can be held in place on the holder, allowing
only the metal parts to be immersed in the water.

As the watch stand / earring holder absorbs about 30% of

the ultrasonic energy, it is recommended to use the ‘Enhanced
Cleaning’ method mentioned earlier in this user guide.

To avoid causing permanent damage:
Never operate the unit without water in the cleaning tank. Never use boiling water.

9

MAINTENANCE AND STORAGE

After use, ensure the unit is unplugged. Pour the water away and wipe the
stainless steel tank and housing with a clean dry cloth.
To avoid electric shock, DO NOT wash the exterior of the unit with water.

The unit should be stored in a cool dry place, away from any heat sources
(radiators etc.) and sources of moisture (bathrooms etc.).
Ideally, the unit should be stored in its original packing for maximum safety.

Made from a unique formula containing natural products, mixing carefully balanced quantities of seaweed,
coconut oils and fruit extracts to create a powerful cleaning solution.

SeaClean2 will expertly clean tarnished items and assist in the removal of carbon, rust and dir t from most
solid metals*, precious stones* and inkjet cartridges to return them to a shiny condition.

Available in 500ml, 1L, 5L and 25L bottles. * Please refer to our website for exclusions.

DOUBLE STRENGTH CONCENTRATE

SPECIFICATION

Description Ultrasonic Cleaner

Model ULTRA 2000

Tank Capacity 420 ml Stainless Steel

Power Supply 30 W (AC 220~240V 50Hz)

Timer Settings 3 minutes with automatic shut-off

Ultrasonic Frequency 45,000 Hz

Tank Material Stainless Steel SUS304

Net Weight 0.63 kg

Unit Size (L W H) 110 x 198 x 124 mm

GUARANTEE

Your Ultrasonic Cleaner has been carefully manufactured and 100% tested using high quality assured

components. It is guaranteed against faulty workmanship and materials for a period of 12 months

from the date of purchase. In the unlikely event that a failure should occur, the unit will be repaired or

replaced* free of charge when returned, postage paid, to the address below within the guarantee period.

This guarantee DOES NOT include damage or failure resulting from misuse, damage in transit or failure

by the user to comply with the Dos and Don’ts (this list is not exhaustive).

Your statutory rights under common law are in no way affected by this guarantee.

James Products Ltd,

Unit 1, Church Close Business Park,

Todber, Sturminster Newton,

Dorset DT10 1JH,

England

Tel: [phone]

Fax: [phone]

When returning your unit please call our Returns Department on [phone]

for a RMA (Returns Materials Authorisation) number. Please return your unit in its original packaging

along with a covering letter stating when and where you purchased the unit and a description of the

problem encountered. If the unit is within the guarantee period please enclose proof of purchase.

LIMITED WARRANTY

Consequential and incidental damages, including without limitation, loss of property and those arising

from breach of any express or implied warranty, are not the responsibility of James Products Limited and

to the extent permitted by law, are excluded.

In accordance with its policy of progressive product design, James Products Ltd reserves the right to

change product specications without prior notice.

*Repair or replacement is at the discretion of the manufacturer.

Registered in England No. 5250754

Registered Ofce: James Products Ltd, Unit 1, Church Close Business Park, Todber, Sturminster Newton, Dorset DT10 1JH, England

www.jamesproducts.co.uk