Jakks Pacific 97109TX, 97109RX User Manual

97109 Skateboarding Mikey IS
size: 16.5”W x 8.5”H x 2
Color: Black & PMS 2593

SELF-RIGHTING FEATURE

If the figure falls over during play, PRESS the SPIN BUTTON to get it upright again.

IMPORTANT SAFETY INFORMATION

- NEVER use near glass and other fragile objects.

- NEVER drive near traffic, buildings, trees, people or other obstructions.

- NEVER operate during storms or other adverse weather conditions.

- ALWAYS point away from face, eyes, people, animals and property when driving.

- ALWAYS use alkaline batteries only.

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE SOLUTION

Skateboard won’t move.

Figure won’t self-right.

Skateboard / Remote Control switch is switched OFF.

Weak Remote Control batteries.

Skateboard is stuck.

Weak skateboard batteries.

Remote Control is not close enough to vehicle.

Figure not in ideal position.

Surface is too smooth.

5 6

Move switch to ON position.

Press any direction button.

If indicator light does not activate,

replace appropriate batteries.

Move skateboard to a smoother

surface, clean wheels, make sure

surface or floor is clean as well.

Replace batteries.

Make sure the Remote Control is placed

within the signal receiving range.

Reset Figure and Skateboard

position manually in open area.

Move the Skateboard to a surface

with more texture and try again.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation
est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit
accepter dout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

JAKKS Pacific® Battery, Solar or Electrically-Operated Product 90 DAY LIMITED WARRANTY

Thanks for purchasing a great JAKKS Pacific® product! Please immediately register your product online at www.jakks.com/warranty. Registration is
not required for the effectiveness of this limited warranty.

IMPORTANT NOTICE TO CONSUMER:
This 90 DAY LIMITED WARRANTY applies to the original product purchaser, provided the product: 1) was purchased from an authorized JAKKS™
distributor/dealer/retailer, and 2) is returned at your expense, postage pre-paid and insured, along with the original dated sales receipt to the address
noted below. Please save a copy of your original sales receipt, as the original receipt will not be returned to you.
If you return the product to us without the original dated sales receipt, this warranty coverage will not apply. If the product is determined by JAKKS
to be defective and returned to JAKKS within the 90 day warranty period, we will (at our option) repair or replace it. Return shipment to you may take
up to 6 weeks, depending upon your location. If your product is repaired or replaced, it will be warranted for the longer of the original warranty or for
30 days after warranty service.

SCOPE OF LIMITED WARRANTY: The product is warranted to be: a) tested and inspected before shipment, and b) free of defects in material and
workmanship for 90 days from date of purchase. If a covered defect occurs within the warranty period, then at our sole option, we will repair or
replace the product or provide you with another product of equal value.

WHAT IS NOT COVERED BY LIMITED WARRANTY:
THIS WARRANTY IS VOID IF THE PRODUCT HAS BEEN MODIFIED OR REPAIRED BY USER OR OTHERS OR IF IT HAS BEEN DAMAGED AS A
RESULT OF ACCIDENT, IMMERSION IN WATER, NEGLECT, ABUSE, MISUSE, BATTERY LEAKAGE, IMPROPER BATTERY INSTALLATION,
UNAUTHORIZED SERVICE, LOSS OF PARTS, WEATHER, ACTS OF GOD, ANY ACTION OR OMISSION WHICH CONSTITUTES A DEVIATION FROM
THE OPERATING INSTRUCTIONS, OR ANY OTHER CAUSES NOT ARISING OUT OF DEFECTS IN WORKMANSHIP OR MATERIALS.

EXCLUSIONS FROM LIMITED WARRANTY: THIS WARRANTY IS EXCLUSIVE OF AND IN LIEU OF ALL OTHER EXPRESS OR IMPLIED
WARRANTIES RELATED TO THIS PRODUCT, INCLUDING ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR
PURPOSE. SPECIAL, INCIDENTAL AND CONSEQUENTIAL DAMAGES ARISING FROM POSSESSION, USE, OR MALFUNCTION OF THIS PRODUCT
ARE EXCLUDED BOTH FOR PROPERTY DAMAGE AND PERSONAL INJURY TO THE EXTENT LEGALLY PERMITTED.

ADDITIONAL LEGAL RIGHTS: This warranty provides specific legal rights. You may have other or different rights in your state or country.

QUESTIONS OR COMMENTS: If you experience product difficulties or have questions or comments, you may contact our Consumer Relations
department as follows:
Phone: [phone] (toll-free, North America only) or 909-594-7771 (Monday-Friday, 7:30AM-4:30PM Pacific/GMT -8).
Mail: JAKKS Consumer Relations, 21749 Baker Parkway, Walnut, California USA 91789.
Email: [e-mail]

WHEN WRITING TO US: Please include: 1) product name; 2) item number; 3) purchase date; 4) description of the problem being experienced; and

5) your name, address and phone number. Additionally, if eligible under the warranty and so advised by JAKKS Consumer Relations, also include
the defective product and the ORIGINAL dated sales receipt evidencing product purchase. Please retain a copy of your receipt.

080309

XPV® RC SKATEBOARDING MIKEY

INSTRUCTIONS

CONTENTS:

- SKATEBOARD

- MIKEY FIGURE

- REMOTE CONTROL

VEHICLE(97109RX):

5X

1.5V C (LR14)

ALKALINE BATTERIES
REQUIRED

REMOTE CONTROL(97109TX):

2X 1.5V AA (R6)
BATTERIES
REQUIRED

TM & ©2016 Manufactured by JAKKS Pacific, Inc., 2951 28th Street, Santa Monica, CA 90405 U.S.A.
All other symbols, marks, logos, and designs (collectively “Trademarks”) are Trademarks of and proprietary to their respective owners and used under
license. Contents may vary in style, color, shape and decoration from images shown on package or in advertising.
Questions or comments? www.jakks.com, [e-mail], or 1-877-875-2557 in North America.
Retain packaging and instructions since they contain important information.
Warning. Not suitable for children under 36 months. Small parts. Choking hazard.
ATTENTION! Remove and discard packaging ties and fasteners before giving toy to child.
MADE IN CHINA.
© 2016 Viacom International Inc. All Rights Reserved. Nickelodeon, Teenage Mutant Ninja Turtles
and all related titles, logos and characters are trademarks of Viacom International Inc.

NOT INCLUDED

INCLUDED

@ 2016 Viacom

CAUTION:

ADULT SUPERVISION REQUIRED

ALWAYS PLAY IN SAFE SURROUNDINGS,

AWAY FROM STREETS OR MOVING VEHICLES.

4+

#97109

2.4GHz

BATTERY REPLACEMENT

ADULT INSTALLATION REQUIRED
Requires 5 "C" (LR14) alkaline batteries (not included) and 2 “

When performance diminishes, replace with fresh batteries.

AA” (R6) batteries (included).

ASSEMBLY

OPERATION

BOTTOM VIEW

1

2

VEHICLE

1. Install 5 - 1.5V “C” (LR14) ALKALINE BATTERIES in the orientation shown.

2. Replace BATTERY COVER and tighten screw.

1

2

REMOTE CONTROL

1. Remove and dispose of the TRY ME tag.

2. Batteries included are for “Try Me” purposes. If performance

diminishes after purchase,replace with fresh batteries.
Install 2 - “AA” (R6) BATTERIES in the orientation shown.

3. Replace BATTERY COVER and tighten screw.

Remove and dispose
of the TRY ME tag

BATTERY SAFETY INFORMATION

WARNING!

Battery acid leakage can cause personal injury and cause damage to the product and surrounding
property. If battery leakage occurs, thoroughly wash any affected skin, making sure to keep battery acid away from
eyes, ears, nose and mouth. Immediately wash any clothing or other surface that comes in contact with leaked battery
acid. Leaking batteries may make "popping" sounds. Dispose according to Local, State or Federal Battery Laws.

TO AVOID BATTERY PROBLEMS:

NEVER mix old and new batteries or different brands of
batteries.
NEVER mix alkaline, standard (carbon-zinc), rechargeable
(nickel-cadmium) batteries with this product.
NEVER dispose of batteries in fire, as they may leak and
explode.
ALWAYS remove exhausted batteries from toy.
ALWAYS have an adult install batteries consistent with
installation instructions.

ONLY use batteries specified by manufacturer.
Batteries are to be inserted with the correct Polarity.
The supply terminals are not to be short-circuited.
Non-rechargeable batteries are not to be recharged.
Rechargeable batteries are to be removed from the toy
before being charged.
Rechargeable batteries are only to be charged under adult
supervision.

2

NOTE:

FIGURE is NOT
REMOVABLE

INDENTS

PEG

1. Align the FIGURE’S TOES with the

indents on the SKATEBOARD PLATFORM.

PLATFORM

INSCRIBED

OUTLINE

TOP VIEW OF PLATFORM: Showing INDENTS and INSCRIBED
OUTLINE of MIKEY’S FOOT. Use INSCRIBED OUTLINE to assist
in assembling the FIGURE to the SKATEBOARD.

2. Insert the FIGURE onto the SKATEBOARD as shown. Align the PEG in the figure’s foot to the SLOT on the

skateboard’s post. Snap FIGURE onto SKATEBOARD.

(UNDER
FOOT)

SLOT

once attached to
SKATEBOARD.
Attempting to
remove figure may
affect performance
and/or permanently
damage product.

CONTROLS

REMOTE CONTROL

TOP VIEW BOTTOM VIEW

ON / OFF SWITCH

SPIN FORWARDSPEAKER TRY ME TAG SLOTBATTERY COMPARTMENT

INDICATOR LIGHT

3 4

1. SKATEBOARD: Move the OFF / ON SWITCH to

the ON position.

3. Place the SKATEBOARD on ground. The left button

operates a counter clockwise spin, which will spin
the figure and/or the skateboard. The right button
operates forward movement.

Note: This vehicle is for indoor use.

Works best on hard surfaces such
as wood, tile, concrete and low pile carpet.
NOT recommended for use on grass,
loose dirt, wet surfaces or high pile carpet.
NEVER use in water or mud.

2.

REMOTE CONTROL: Move the OFF/ON SWITCH to the
ON position. The INDICATOR LIGHT will blink. When
the unit is paired with the VEHICLE, the LIGHT will be

solid.

NOTE: If INDICATOR LIGHT keeps flashing for a long

time, switch off both VEHICLE and REMOTE CONTROL
and repeat the pairing process.

NOTE: Pairing is required every time the VEHICLE/

REMOTE CONTROL is turned on.