Bar Code Scanner (USB)
Installation Instructions
Follow these instructions to connect and program any of these USB bar code scanners:
• JADAK flexpoint HS
mbol LS2208 on the NanoMaxx, M-Turbo, or S Series ultrasound system
• Sy
When connected, the bar code scanner is listed on the system’s USB or USB Devices setup page.
See the Bar Code S
-1M on the X-Porte, Edge, M-Turbo, S Series, or NanoMaxx ultrasound system
canner User Guide from FUJIFILM SonoSite for information on safety and cleaning.
Configuring the JADAK bar code scanner
To connect and program the Jadak bar code scanner
1 Attach the scanner cord to the bar code scanner and to a USB port on the ultrasound system.
See JA
DAK flexpoint HS-1M Quick Start Guide included with the bar code scanner.
For location of USB ports, see the ultrasound system user guide or Help (X-Porte only).
2 T
urn on the ultrasound system.
3 S
can the following two bar codes in the order listed:
USB Kybrd
STX Prefix
ETX Suffix
DOS CTRL
ASCII MODE
4 To ensure the scanner has been configured to work with your ultrasound system, FUJIFILM SonoSite
recommends opening a patient information form on your system and scanning a bar code. Your system is
successfully configured when you scan a bar code and the patient ID (and associated patient information, if
any) populates the patient information form.
Configuring the Symbol bar code scanner
To connect and program the Symbol bar code scanner
1 Attach the scanner cord to the bar code scanner and to a USB port on the ultrasound system.
See S
ymbol LS2208 Quick Start Guide included with the bar code scanner.
For location of USB ports, see the ultrasound system user guide.
2 T
urn on the ultrasound system.
3 S
can the following 9 bar codes in the order listed:
For instructions to scan, see Symbol LS2208 Quick Start Guide.
Note: If you have trouble scanning a bar code, try holding the scanner farther away from the bar code or at a
different angle.
2
4 Scan additional programming bar codes as desired.
5 To ensure the scanner has been configured to work with your ultrasound system, FUJIFILM SonoSite recommends
opening a patient information form on your system and scanning a bar code. Your system is successfully configured
when you scan a bar code and the patient ID (and associated patient information, if any) populates the patient
information form.
Note: You can program the scanner with various user preferences, such as beeper volume. Refer to Symbol LS2208 Quick Start
Guide or, for more comprehensive information, to the Symbol LS 2208 Product Reference Guide, included with the scanner and
available on the Motorola Web site at www.motorola.com.
3
X-Porte, Edge, M-Turbo, NanoMaxx, S Series, SonoSite, and the SonoSite logo are registered or unregistered trademarks of
FUJIFILM SonoSite, Inc. in various jurisdictions.
All other trademarks are the property of their respective owners.
Copyright© 2013 FUJIFILM SonoSite, Inc. All rights reserved.
Manufacturer
FUJIFILM SonoSite, Inc.
21919 30th Drive SE
Bothell, WA 98021 USA
T: 1-888-482-9449 or
1-425-951-1200
F: 1-425-951-1201
4
EC Authorized
Representative
Emergo Europe
Molenstraat 15
2513 BH, The Hague
The Netherlands
Australia Sponsor
FUJIFILM SonoSite
Australasia Pty Ltd
Suite 9, 13a Narabang Way
Belrose, New South Wales 2085
Australia
P12173-06
*P12173-06*
7/2013
Loading...