Chromatherapy Light Kit
instaLLation and operation instruCtions
The Jacuzzi Chromatherapy Lamp provides beautiful and
practical illumination to your bath. It includes vivid rotating colors
or penetrating white lighting to enhance your Jacuzzi experience,
and is built to give years of service and pleasure.
The Lamp can be installed on most Jacuzzi baths or on any
bath having sufcient at space on the bath shell. The basic kit
consists of an electrical control box and one Chromatherapy
Lamp, with all necessary modular cables. The control box can
support up to four lamps. An additional lamp kit is available and
provides one lamp and one cable.
The installation requires drilling a hole in the bath shell for the
control panel and each lamp. The Installation and Operation
Instructions will provide all the information required for planning
the installation, completing the installation, and complete
operation of the equipment. The control box must be installed
meeting applicable local building and electrical codes on a stud
beam or wall.
Contents
Basic Lamp Kit . . . . . . . . . . . . . . . . . . . . . . 1
Planning Installation . . . . . . . . . . . . . . . . . . . 1
Control Panel . . . . . . . . . . . . . . . . . . . . . 2
Chromatherapy Lamp . . . . . . . . . . . . . . . . 2
Mount the Control Box . . . . . . . . . . . . . . . . . . 3
Drill the Holes . . . . . . . . . . . . . . . . . . . . . . 3
Drill Hole for Control Panel . . . . . . . . . . . . . . 3
Drill Hole for Lamp(s) . . . . . . . . . . . . . . . . . 3
Install Panel and Lamp(s) . . . . . . . . . . . . . . . . 4
Mount Control Panel . . . . . . . . . . . . . . . . . 4
Mount Chromatherapy Lamp(s) . . . . . . . . . . . 4
Leak Test . . . . . . . . . . . . . . . . . . . . . . . . 5
Operate Chromatherapy Lighting . . . . . . . . . . . . 5
Use Chromatherapy Lighting . . . . . . . . . . . . . 5
Control Chromatherapy Lighting . . . . . . . . . . . 5
Control Color Lighting . . . . . . . . . . . . . . . 5
Control White Lighting . . . . . . . . . . . . . . 5
BasiC Lamp Kits
GD56000 Complete kit
One control box for wall mounting
One control panel and one control cable (RJ-45 plug)
One lamp and one lamp cable (RJ-11 plug)
GQ88000 Accessory lamp kit
One lamp and one lamp cable (RJ-11 plug)
To add an additional lamp, up to four total, order the accessory
lamp kit. It includes one lamp and one lamp cable. Each lamp
is mounted in the same manner, and is connected to the control
box as described. To order additional lamps, please contact your
Jacuzzi dealer or agent.
important: Read the instructions before beginning the
installation.
pLanning instaLLation
It is necessary to plan the location of the control box, control
panel, and each lamp before drilling any holes. A possible
conguration of the Chromatherapy equipment is shown in
Figure 1.
First, consider the location requirements for the control panel and
lamp(s), see Figure 2. The control panel cannot be immersed
in the bath water. Therefore it must be positioned at least one
inch above the level of the overow drain. On the other hand,
the lamp(s) must be positioned a minimum of 4 inches below the
normal water line.
Control panel
Lamp 1
Lamp 2
Figure 1. Possible conguation for Chromatherapy assembly
Top rim of bath
Hole for control panel
1 inch
Overow drain
Normal water line
4 inches (minimum)
Hole for lamp(s)
Floor of bath
Figure 2. Locate the Holes for Control Panel and Lens(es)
Copyright © 2008 by Jacuzzi Whirlpool Bath Products GQ99000 • 07-08
Caution: The panel and lamp(s) require modular cables from
behind. Make sure the proposed location of the panel and lamp(s)
will not cause cables to interfere with the bath plumbing
The control panel and each lamp must be mounted on a minimum
at surface space of the bath shell, see Table 1, Mounting Surface
Requirements.
5/32 inch1-1/16 inch
Table 1. Mounting Surface Requiements
EQUIPMENT FLAT MOUNTING SURFACE
----------------------------------------------------------------------- Control panel 3 x 2 inches
Lamp (each) 2-1/2 by 2-1/2 inches
Next, consider the following cable lengths, starting with the control
box. See Table 2, Cable Lengths.
Table 2. Cable Lengths
CABLE LENGTH
------------------------------------------------------- Control box cable 32 inches
Control panel cable 72 inches (6 feet)
Chromatheraphy lamp 84 inches (7 feet)
The control box must be mounted on a stud beam or secure wall
within 32 inches of the GFCI power outlet. The outlet must be a
minimum of 4 inches above the oor. In addition it must be located
no further than the length that the modular control cable or any
lamp cable may extend.
Once the location of the control box has been determined, you
may determine the location of the control panel and the lamp(s),
and prepare to drill a hole for each item.
d e t a i L
1/2 inch
Figure 3. Hole for Control Panel
1-5/8 inch
Control Panel
Before marking the inside of the bath shell, place masking tape
over the entre area of the proposed hole. The tape will help
prevent chipping of the acrylic.
Writing on the tape, use a pointed marker to indicate the outline of
the hole for the control panel, see Figure 3. The control panel is
2-1/2 by 1-1/2 inches and requires a minimum of 3 by 2 inch at
mounting surface. Carefully mark the center of the hole.
Also mark the 5/32 inch notch at the right side of the diameter,
and mark the center of the notch. It is critical to measure the hole
and notch precisely.
Chromatherapy Lamp
Use a marker to indicate on the inside of the bath shell where the
lamp(s) will be located
Caution: Before marking the inside of the bath shell, place
masking tape over the entire area of the proposed hole, to help
prevent chipping of the acrylic.
Use a marker to indicate the location of the Chromatheraphy
lamp(s). The lamp is 2 inch diamerter and requires a minimum
of 2-1/2 diameter at mounting surface. (Locate as many lamps
as are intended for installation.) Indicate a hole for 1-5/8 inch
diameter, see Figure 4.
Figure 4. Hole for Chromatherapy Lamp(s)
Jacuzzi© Chromatherapy: Installation and Operation Page 2 of 5 GQ99000 • 07-08
Lens cable (1-4)
Loading...