Jacob Jensen 80 User Manual
Telephone 80
DECT
Generation to generation…
JACOB JENSEN
TM
User manual
2
ACCESSORIES & CONTENTS
1. 2. 3. 4.
5.
The following items are included in the package
of JACOB JENSENTM Telephone 80, with country
adaptor (optional):
1. Telephone Handset
2. Base Station
3. Wall mount plate + screws and plugs
4. Power supply unit
5. Li-ion 3.7V 650mAh Battery
6. Combo jack
7. Combo cord
8. Line cord
7. 8.6.
3
ILLUSTRATION DIAGRAM
Handset
1. Earpiece
2. Side speaker
3. LCD Screen
4. Function Keys
5. Dial Number Keys
6. Microphone
7. Battery Compartment
(under the handset)
8. Handset charging contact
Base
9. Base charge contacts
10. Charge indicator
11. Page key
11.
9.
10.
MAIN FEATURE LIST
12 hours talk time
7 days standby time
Low radiation
LCD type, 14 digit X 3 line + icons
Flash selectable 80-800 ms
Caller ID Type 1&2 and DTMF
Call Log List
Hands-free
Speaker and ringer volume
100 phonebook memory locations
HS intercom
3-Party conference
Call Transfer between HS
Alarm call and date reminder
7 midi/polyphonic ringtones
Room monitor
Equalizer
Li-ion battery
Pan-European approved:
EN 55022 and EN 55024
US: FCC Part 68 rules
(including tone/pulse selection)
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
1.
2.
3.
5.
6.
8.
4.
7.
When using your telephone equipment, basic safety precautions
should always be followed to reduce the risk of fire, electric shock
and injury to persons, including the following:
Do not use this product near water, for example, near a
bath tub, wash bowl, kitchen sink or laundry tub, in a wet
basement or near a swimming pool. Do not allow the handset
to come into contact with liquids or moisture.
Avoid using a telephone (other than a cordless type) during
an electrical storm. There may be a remote risk of electric
shock from lightning.
Do not use the telephone to report a gas leak in the vicinity
of the leak.
Use only the power cord and batteries indicated in this
manual. Do not dispose of batteries in a fire. They may
explode. Check with local codes for possible special disposal
instructions.
Plug the adaptor to a socket-outlet that is close to the
equipment and easily accessible.
Do not open the handset, base station or charger. This could
expose you to high voltage.
Do not allow the charging contacts of the charger or the
battery to come into contact with extraneous conductive
materials.
Young children should be supervised to ensure that they do
not play with the telephone.
Since the phone works by sending radio signals between
the base unit and the handset, wearers of hearing aids may
experience interference in the form of a humming noise.
We advise that this phone should not be used near intensive
care medical equipment or by persons with pacemakers.
Your phone can interfere with electrical equipment such as
answering machines, TV, and radio sets if placed too close. It
is recommended that you position the base unit at least one
meter form such appliances.
SAVE THESE INSTRUCTIONS
•
•
•
•
•
•
•
•
•
•
•
IMPORTANT SAFETY INSTRUCTION
4
A. INSTALLATION AND START-UP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
B. DISPLAY SYMBOLS AND THEIR INDICATION. . . . . . . . . . . . . . . . . . . . . . . . 6
C. BUTTONS AND THEIR FUNCTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
D. PREPARATION BEFORE USE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
E. NORMAL OPERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
F. PHONE BOOK . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
G. CALLER IDENTIFICATION MEMORY (CALLER ID) . . . . . . . . . . . . . . . . . . . . 14
H. PERSONALIZING YOUR PHONE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
I. ADVANCED OPERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
J. REVERTING TO FACTORY DEFAULT SETTING. . . . . . . . . . . . . . . . . . . . . . . 16
K. MAINTENANCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
L. TROUBLESHOOTING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
M. ENVIRONMENTAL CARE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
N. WARRANTY AND SERVICES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18
O. FCC COMPLIANCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18
US
Congratulations on your new JACOB JENSENTM Telephone.
The Telephone 80 is designed in Denmark by Jacob Jensen, whose products have
gained international recognition for their original, simple and classic design. It is a
state of art device created with consideration of form and function. The Telephone
80 is designed for both desktop and wall mounting and a wall mounting bracket is
included in the gift box.
The Telephone 80 is powered with the latest digital technology – DECT system
(Digitally Enhanced Cordless Telecommunication). It brings you digital sound,
penetrating range and user-friendly menu-driven functions. According to the DECT
system standard (GAP compatible), six different handsets can be registered to a single
base unit to perform function of a mini-PABX system which offers you functions of
intercom and call transfer between handsets. In addition, its built-in Caller ID decoder,
Phone Book, Redial List and Caller ID memory provide you great convenience to
manage your phone calls.
The Telephone 80 is equipped with a low radiation feature in both the base and the
handset. It works intelligently by detecting and adjusting the strength of the radio
frequency signal (RF) depending on the distance between the handset and the base as
well as the number of handsets attached. This is done automatically so that the system
will always adjust the strength of the RF-signal to the lowest possible.
A. INSTALLATION AND START-UP
The cordless phone system can only work under constant power supply to the base
station. It is advisable that another corded phone (works without mains power supply)
is connected to your phone system for emergency call purpose in case of power failure.
Caution
Use only the Ktec Model KSLFB0750035W1US power adaptor unit that came with
the unit. Using other power adaptors may damage the unit and invalidate your
warranty.
Plug the adaptor to a socket-outlet that is close to the equipment and easily
accessible.
•
•
5
1. Connect the combo cord to the RJ45 jack of the combo jack.
2. Plug the power supply unit into the main wall outlet and connect the other end
to the RED jack of the combo jack.
3. Connect one end of the telephone line cord to the BLACK jack of the combo jack;
connect the other end of the telephone line cord to the country telephone plug
adaptor (optional).
4. Connect the country telephone plug adaptor to the wall outlet for telephone.
A.1. Wall mounting
1. If you desire wall mounting, replace the desktop cover with the wall mounting plate.
Mount the plate using the enclosed screws and plugs for 6 mm drill.
Caution
Risk of explosion if the battery is replaced by an incorrect type. Use only the RTX
battery model 60020437, 3.7V 650mAh Li-ion rechargeable battery pack.
Dispose of used batteries according to the instructions.
You must install the handset battery before using the cordless handset.
Li-ion batteries must be disposed of in accordance with the applicable waste
disposal regulations.
Do not dispose of the battery in fire. It may explode. Check with the local codes
for possible special disposal instructions.
Keep batteries out of the reach of children
2. On the handset, firmly slide and remove the handset back cover, install the
rechargeable battery pack into the battery compartment. Slide back the handset
back cover. The LCD screen will light up as soon as the battery is installed.
•
•
•
•
•
•
6
3. Put the handset into the base unit, according to the picture shown below. Make
sure that the LED charge indicator on the base unit lights up to show charging is in
progress. The charging icon also appears on the screen of the handset. While
charging, the bars in the icon scrolls and when the handset is fully charged, all the
bars of the battery will be filled.
OR
Important notice
To obtain the best battery performance, keep the handset being charged for
six hours after first time installation.
When the handset is removed from the base, the LED in the base will stay on
for approximately five seconds before it will fade out.
Remove the battery from this product if storing over 30 days.
A.2. Setting language
After the initial charging of six hours you can start using your telephone. If you
would like to choose another language than the pre-set English, do as follows:
Press and press three times to select Display press
press
twice to select Select Lang. Press
press
to select your desired
language: English, Deutsch, Français, Italiano, Nederlands, Español, Dansk, Svenska,
Türkçe, Norsk
and press
.
A.3. Replacement of battery
Depending on your usage, it is recommended to change the rechargeable battery
every year to achieve the best performance.
To replace the battery, follow the instructions below:
1. Prepare one rechargeable battery, 3.7V 650mAH Li-ion battery, part number
60020437.
2. Gently remove the handset back cover, remove the old battery.
•
•
•
3. Observe polarity marks inside the battery compartment, and insert the rechargeable
battery. It is not possible to connect the battery with wrong polarity.
4. Replace the handset back gently; making sure the orientation of the battery
compartment cover is correct.
B. DISPLAY SYMBOLS AND THEIR INDICATION
In standby / Idle mode:
Symbol Indication
01/20 It shows the current date in month/date format.
02:05 It shows the current time in 12 hours format.
Always displays when your handset is on, shows the battery status.
Loading...