3
IMPORTANT SAFEGUARDS
READ THESE SAFEGUARDS CAREFULLY
BEFORE USING THIS PRODUCT!
When using electrical appliances, basic safety precautions should always
be followed including the following:
• Read all instructions.
• NOT FOR USE BY CHILDREN! Keep out of the reach of children to avoid
injury. This appliance is not a toy.
• Do not operate this or any appliance with a damaged AC cord or plug.
• Do not operate if appliance malfunctions, has been dropped or appears
damaged in any manner. Never attempt home repairs. Only a qualied
appliance technician should repair appliance before re-use.
• To avoid electric shock or serious personal injury, do not use any
attachments or utensils that were not recommended or supplied by the
manufacturer.
• To protect against risk of electrical shock or injury, never immerse power
cord, plug, or main unit in water, or other liquids.
• Do not let Power Cord hang over the edge of table, counter, or come in
direct contact with hot surfaces such as stoves.
• Make sure the Lid is attached properly and is securely locked before
operating the Power Juicer. (See Assembly Step 5.)
• Make sure the motor stops completely and the unit is unplugged from the
electrical outlet before disassembling, assembling or cleaning.
• Should juicer suddenly stop or develop excessive vibration or unusually
loud noise, shut off and unplug unit immediately, wait for Blade to stop
running, then disassemble, clean thoroughly and reassemble.
• To avoid risk of personal injury keep hands and utensils out of the juicer
and away from its sharp Blade during operation. Use the Pusher, not
ngers or utensils, to feed the produce into the juicer.
• Never disengage the Locking Bar during operation.
• The juicer Blade is extremely sharp. Use extreme caution when handling.
• Should food become lodged in the Chute, and moderate Pusher pressure
will not dislodge it, turn the Power Switch off, allow the motor to stop
completely, then unplug the AC cord, disassemble the juicer and remove
the blocked food.
• Avoid personal injury. Never assemble the unit without using all
components in their proper sequence, making certain the Blade is properly
seated and secured in the Filter and Receptacle.