SPECIFICATIONS
JACK® Digital HDTV Over-the-Air Antenna
w/built-in SureLock® Digital TV Signal Meter
OA8200 - White • OA8201 - Black
Dimensions: 11.25” H x 16” W x 12.5” L
Weight: 2.3 lbs.
Frequency Bands: VHF (47-230 Mhz) - 20 db gain
UHF (470-860 Mhz) - 25 db gain
Signal Meter
Frequency Response: 40-862 Mhz (Ch 2-69)
The Wall Mount Power Injector is a convenient way to
switch between your cable feed and over-the-air signals
from your JACK antenna.
To use the Power Injector, simply turn the unit on with the
ON/OFF button. When on (button depressed), the power
light will turn green indicating +12 volts to the antenna,
and the over-the-air signal from your JACK antenna will
be fed to the two TV outputs.
When off, the cable TV signal will be fed to the two TV
outputs if wired for cable TV input.
Powered Amplier: +12 Volt / 100 mA working
Power Supply: Wall Mt. Switch (included)
• Mfr. # PB1000 - power supply, white
Enclosure/Mount: ASA-Automotive grade
OPERATION
1. Turn on antenna power at Power Injector Wall Mount Plate.
2. Turn on SureLock Signal Meter with switch on side of rotational knob enclosure.
3. Rotate attenuator dial fully clockwise.
NOTE: In step 4, LED lights will illuminate from left (next to power) to right.
All LED lights may not illuminate depending on signal strength.
4. Depress button on rotational knob and rotate antenna
until maximum number of LED lights illuminate on signal meter.
5. Rotate attenuator dial counter clockwise until last illuminated LED light ickers.
6. Rotate antenna to illuminate last ickering LED light.
7. Repeat steps 5 and 6 to pinpoint signal reception.
8. Follow instructions for TV or converter box to scan for available channels.
POSITIONING THE ANTENNA
NOTE: Arrow on knob indicates which
direction antenna is pointing.
Page 1
OVERVIEW (FIG. 1 & 1-A)
NOTE: Please read thru the instructions before beginning.
1. Verify contents and familiarize yourself with the parts (FIG. 1).
IF YOUR ROOF IS LESS THAN 3 1/2” THICK,
PROCEED TO THE NEXT PAGE.
You only have to install the supplied longer connector for roofs
thicker than 3 1/2”.
If using the longer connector, install it now,
BEFORE INSTALLING BASE MOUNT ON ROOF (FIG. 1-A).
• Remove the existing adjustable connector from the upper
connector located in the base mount.
• Line up the tab with the shorter side as shown at right and engage
the longer connector onto the upper connector.
• Leave connector sticking out of base mount more than the
thickness of the roof.
FIG. 1-A
IMPORTANT!
For roofs 3 1/2” to 6” ONLY!
IMPORTANT!
The point of the base mount must
face towards the front of the vehicle.
IMPORTANT!
There are two lengths of adjustable
connectors included.
For roof thicknesses 1 1/4” to 3 1/2”
use the assembly as shipped.
For roof thicknesses 3 1/2” to 6”
use the longer connector.
FIG. 1
IMPORTANT!
You must install
the included
wall mount switch
KC# PB1000
to operate the
JACK antenna.
(See page 5)
Page 2
Loading...