Page 1
Care and Cleaning
Estimated Assembly Time:30 minutes
Part List and Hardware List
CAUTION: Read instruction carefully and turn electricity off at main circuit
breaker panel before beginning installation.
Assembly Instruction
To clean the outside of the fixture, use a dry or slightly dampened clean cloth(use clean water,
never a solvent) to wipe the surface of the fixture.
To clear the inside of the fixture, first disconnect power to the fixture by turning off the circuit
breaker or by removing the fuse at the fuse box. Next, use a dry or slightly dampened clean
cloth(use clean water, never a solvent) to wipe the interior surface of the fixture
Do not use any cleaners with chemical, solvents or harsh abrasives. Use Only a dry soft cloth
to dust or wipe carefully.
1/3
Page 2
Installation
Step 1
Step 2
Step 3
Step 4 Wire connection
Using the Wire Nut (A) connected the positive
electrode and the negative pole of the fixture body
carefully into the positive electrode and the
negative pole in junction box.
Thread Stem (I) to the Fixture Body(N), then
thread the Canopy (G) to the Stem (I).
*Parallel Cord(round&smooth)
*Parallel Cord(square&ridged)
Clear,Brown,Gold or Black without Tracer(colored stripes)
Clear,Brwn,Gold or Black without Tracer(colored stripes)
Insulated Wire(not green)with copper metal conductor
Insulated Wire(not green)with Silver metal conductor
Attach the Mounting Plate (B) to the junction box
using the Outlet Box Screw (D) on the ceiling wall.
Connect,Hot,Black or Red outlet Supply Wire to:
Connect,Neutral,White Outlet Supply Wire to:
Black
White
2/3
Page 3
*Note: When parallel wire(SPTI&SPTII)is used. The neutral wire is square shaped and
ridged and the hot wire will be round in shape and smooth.(See illustration on left)
Grounding Instructions:
Step 5
Step 6
Consult a qualified electrician to ensure correct branch circuit conductor.
ENJOY YOUR LAMP
a) For installation in the United States: Wrap ground wire from outlet box around green ground screw on
mounting bracket, no less than 2" from wire end. Tighten ground screw. If fixture is supplied with a ground wire,
connect to outlet ground wire with a wire connector.
b) For installation in Canada: If fixture is supplied with ground wire, wrap ground wire around green grounding
screw on mounting bracket. Tighten ground screw.
Attach the Canopy (G) through Mounting Screw
(C), secure Canopy (G) with Finial (H) to Mounting
Screw (C).
Slide the Tubes (K) over the sockets, Insert the G9
bulbs (L) into the sockets, and then thread the Bulb
Shields (J) to the Fixture Body (N) as shown.
PLEASE USE TYPE G9 LED BULB MAX. 5WATT.
THERE ARE 12*2-WATT G9 LED BULBS IN THE
BOX.
3/3
Loading...