Page 1
Assembly Instructions
Caution: You must read this before you proceed
Chair
Caution: This Chair is NOT a TOY.
Keep your child/children at bay during the assembly process.
Whenever moving/lifting the Loveseat and to prevent damage to the Chair,
two adults are required to execute these actions.
1 of 7
Page 2
Part List
Label Picture Description Qty
A Seat Panel 1
B Backrest Panel 1
C Right Panel 1
D Left Panel 1
E Support Bar 1
F Seat Cushion 1
G Back Cushion 1
Hardware
No. Picture Description Qty
①
②
③
2 of 7
Screw (M7x70mm) 5
Screw (M7x120mm) 3
Allen Key 2
Page 3
Assembly Preparation
Before Beginning Assembly:
Assembly Steps
Overview
Backrest Panel (B)
Left Panel (D)
This Chair has multiple parts and may require up to 30 minutes to assemble. To give
you an overview of the Chair parts, the above picture is to help you put the various parts
into perspective. Please read through the instructions below to familiarise yourself with
the parts and steps before assembly.
Back Cushion (G)
Right Panel (C)
Seat Cushion(F)
Seat Panel (A)
Support Bar
(E)
FRONT FACING
3 of 7
Page 4
Step 1
Unpack and place all parts on a clean, non-marring surface.
Step 2
B
③
D
With the help of your adult partners, attached the tenons of Backrest Panel (B) and
Support Bar (E) into the mortises of Left Panel (D) using Bolt (①,②)
Key(③) as shown in picture above.
Repeat the same process with the Right Leg (C)
Do not fully tighten the Screw.
E
①
③
②
with Allen
4 of 7
Page 5
Step 3
Insert Seat Panel (A) into assembled on step 2 as pictured above.
A
Step 4
F
Place Seat Cushion(F), onto the Chair, and affix the velcro straps around the Chair as
shown above.
5 of 7
Page 6
Step 5
G
Place Back Cushion(G) onto the Chair.
Then EXERT pressure, floorwards onto the Chair with both hands.
This pressure will help the Chair reach full alignment at all joints.
In a sequential manner, gradually tighten alScews at all joints until evenly secured.
Inspect the Chair and make sure all parts are adequately connected.
Your Chair is ready for use.
This Chair can only be used on a flat, level surface.
6 of 7
Page 7
7 of 7
Loading...