Page 1
ASSEMBLY INSTRUCTIONS
300345Q (B1-B3)
COASTER FINE FURNITURE
REVISION 0 : 08/13/2014
REVISION 1 : 04/06/2015
REVISION 2 : 05/14/2015
REVISION 3 : 07/25/2019
PAGE 1 OF 4
Queen Bed
COASTERFURNITURE.COM
Page 2
ASSEMBLY INSTRUCTIONS
FROM BOX 2 & BOX 3
ASSEMBLY TIPS:
1. Remove hardware from box and sort by size.
2. Please check to see that all hardware and parts are present prior to start of assembly.
3. Please follow attached instructions in the same sequence as numbered to assure fast & easy assembly.
WARNING!
1. Don’t attempt to repair or modify parts that are broken or defective. Please contact the store
immediately.
2. This product is for home use only and not intended for commercial establishments.
ASSEMBLY TIME 20 MINUTES
PARTS IDENTIFICATION
B1 ( BOX 1)
AN HEADBOARD 1PC BN
ROLL SLAT
(14PCS)
1SET
B2 ( BOX 2)
CN FOOTBOARD PANEL 1PC
B3 ( BOX 3)
DN LEFT BED RAIL 1PC IN CENTER RAIL 1PC
300345Q (B1)
EN RIGHT BED RAIL 1PC AN
FN FOOTBOARD LEG 2PCS
FBN
BED SLAT SUPPORT
GN
HN
WITH LEVELER
FOOTBOARD
SUPPORT WITH
LEVELER
3PCS
1PC
FROM BOX 1
HEADBOARD
300345Q (B2&B3)
FOOTBOARD
COMPLETE
1PC
1PC
Z-B3 (BOX 3) - HARDWARE PACK IS LOCATED IN 300345Q (B3)
SHORT FLAT HEAD
1
2
3
NOTE:
Phillips head screw driver is required in the assembly process; however, manufacturer does not provide this item.
SCREW
(4 x 25mm - RBW)
LONG FLAT HEAD
SCREW
(4 x 32mm - RBW)
BOLT
(6x 40mm - RBW)
HARDWARE IDENTIFICATION
SMALL ALLEN
12PCS 4
31PCS 5
3PCS
PAGE 2 OF 4
WRENCH
(4 X 65MM - BLK)
BIG ALLEN WRENCH
(5 X 70MM - BLK)
COASTERFURNITURE.COM
1PC
1PC
Page 3
ASSEMBLY INSTRUCTIONS
STEP 1 STEP 2
FN
AN
1
DN
HN
CN
EN
FB
N
STEP 3 STEP 4
4
3
IN
GN
1
IN
IN
PAGE 3 OF 4
COASTERFURNITURE.COM
Page 4
ASSEMBLY INSTRUCTIONS
Please tear off the Sticker
STEP 5
BN
5
2
STEP 6
COMPLETE
PAGE 4 OF 4
COASTERFURNITURE.COM
Page 5
INNER SIZE : 60.62'' x 81.10''
65.16''
Distance from ground to the
Top of slat (in inch)
11.22''
14.57''
57.87''
4.53''
4.53''
27.76''
2.76''
27.76''
40.16''
97.64"
Note : Dimension tolerance ±5%
COASTERFURNITURE.COM
Loading...