Ivy Bronx W002675594 Installation & Assembly

Caution : You must read this before you proceed

Chair

Label Picture Description QTY

A Seat 1

B

Right Armrest

(with Pre-Installed

Levellers)

1

C

Left Armrest (with

Pre-Installed

Levellers)

1

D Seat Cushion 1

E Back Cushion 1

Page 1

Label Picture Description QTY

①

Bolt (M6*40MM) 5

②

Bolt (M6*32MM) 3

③

Washer 7

④

Allen Key 1

Before

Beginnin

g

Assembly

:

Overview

This Chair has multiple parts and may require up to 30 minutes to assemble. To give you
an overview of the Chair parts, the above picture is to help you put the various parts into
perspective. Please read through the instructions below to familiarise yourself with the
parts and steps before assembly.

FRONT FACING

Right Armrest(B)

X5

X3

X7

Seat(A)

Left Armrest(C)
Back Cushion(E)

Seat Cushion(D)

Page 2

Step 1

Open the carton and place all the parts onto a clean, non-marring surface.
Place the Right Armrest(B) facedown.

1.1) With the assistance of your adult partner, turn the Seat(A) over and align it to the
Right Armrest(B).

1.2) Attach Seat(A) to Right Armrest(B) using Bolts(①) and Washers(③) with Allen Key(④)
as shown above.
Attach Seat(A) to Right Armrest(B) using Bolt(②) and Washer(③)with Allen Key(④) as
shown above.

Do not fully tighten the Bolts.

Step 2

Place the Left Armrest(C) facedown.

2.1) With the assistance of your adult partner, turn the Seat(A) with Right Armrest(B) over
and align it to the Left Armrest(C).

2.2) Attach the Seat(A) to the Left Armrest(C) using Bolts(①) and Washers(③) with Allen
Key(④) as shown above.
Attach the Seat(A) to the Left Armrest(C) using Bolt(②) and Washer(③) with Allen Key(④)
as shown above.

Do not fully tighten the Bolts.

1.1

1.2

2.1

2.2

Page 3

Step 3

In a sequential manner, proceed to tighten all Bolts.
DO NOT tighten any Bolt fully and then move on to the next one, this may cause the
frame to warp.

Then, with the assistance from an adult partner, stand the Chair upright.
Adjust the Pre-installed Levellers until the Chair is level with the ground.
To adjust the Levellers: with the assistance from an adult partner, tilt the Chair to rest on
two feet.
Adjust the levellers to the desired height to avoid wobbles.

Step 4

Place the Seat Cushion(D) and Back Cushion(E) on the Chair.
Your Chair is ready for use.

This Chair can only be used on a flat and level surface.

Back Cushion(E)

Seat Cushion(D)

Page 4

Page 5