Ivy Bronx W002379852 Installation & Assembly

Assembly Instructions

Caution: You must read this before you proceed

Chair

Caution: This Chair is NOT a TOY.
Keep your child/children at bay during the assembly process.
Whenever moving/lifting the Chair and to prevent damage to the Chair, two adults are
required to execute these actions.

1

Label Picture Description QTY

A Backrest Panel 1

B Seat Panel 1

C Support Bar 1

D Left Arm Panel 1

E Right Arm Panel 1

F Seat Cushion 1

G Back Cushion 1

Label Picture Description QTY

①

Screw

(M7*50mm)

3

②

Screw

(M7*80mm)

5

③

Allen Key

2

Parts List

Hardware

2

Overview

This Chair has multiple parts and may require up to 30 minutes to assemble.
To give you an overview of the Chair parts, the above picture is to help you
put the various parts into perspective. Please read through the instructions
below to familiarise yourself with the parts and steps before assembly.

Assembly Steps

Assembly Preparation

Before Beginning Assembly:

Right Arm Panel

(E)

Support Bar

(C)

Backrest Panel

(A)

Seat Panel

(B)

Left Arm Panel

(D)

Back Cushion (G)

Seat Cushion

(F)

FRONT FACING

3

Step 1

Unplace and place all parts on a clean, non-marring surface.

Step 2

With the help of your adult partner, insert the tenons on Brackrest Panel(A) and
Support Bar(C) into mortises of Left Arm Panel(D).
Attach Backrest Panel(A) and Support Bar(C) to Left Arm Panel(D) using Screws(①),
and Screw(②) with Allen Key(③) as pictured above.

Do not fully tighten the Screws.

4

Step 4

Step 3

Insert the tenons on Brackrest Panel(A) and Support Bar(C) into mortises of Right Arm
Panel(E).
Attach Backrest Panel(A) and Support Bar(C) to Right Arm Panel(E) using Screws(①),
and Screw(②) with Allen Key(③) as pictured above.

Do not fully tighten the Screws.

Insert Seat Panel(B) into assembled Chair frame as pictured above.

5

Place the Chair on a LEVEL SURFACE.
Gently and carefully sit into the Chair.
This will help to align all Parts and Screws fully.
Test the Chair for wobbles.
If no wobbles are found then proceed to tighten all Screws in a sequential manner.

Do not tighten any Screw fully and then move on towards the next one, this could
cause the frame to warp.

Place Seat Cushion(F), and Back Cushion(G) onto the Chair, then secure the velcro
straps to the Chair as shown above.
Your Chair is ready for use.

This Chair can only be used on a flat, level surface.

Step 5

Locked

6

7