Page 1
PIECE
CARE AND MAINTENANCE
Spot clean using a mild water-free solvent. Only a professional cleaner should undertake a complete overall
cleaning.
The use of steam or water-based cleaners may cause excessive shrinking or staining.
NOTICE
* Please make sure that you have all parts indicated before you begin assembly of this item
* This item should be assembled on a soft surface to prevent scratching the finish during assembly
* This item may require periodic tightening
The levellor in the legs are adjustable and can be adjusted to level the product as per floor.*
Part List and Hardware List
A
TOP PART
Leg
B
ALLEN BOLT CSK
HW1
HW2
WASHER 16X8
HW3
Allen key 4 mm
DESCRIPTION PICTURE
16X6
QUANTITY
1X
4X
12X
12X
1X
Product dimensions: 34.6"W* 15.7"D* 29.9"H
WARNING
Weight Capacity - 110 LBS
Warning : Do not stand on Desk
Warning : Do not over torque nolts.
The legs and hardware are located under the drawer
Page 2
STEP2 PUT THE WASHERS (H2) ON THE ALLEN BOLT (H1) IN THE ORDER SHOWN
STEP3 INSERT ALLEN BOLT WITH WASHER INTO THE
ALLEN KEY(H3).
STEP1 OPEN THE ZIPPER ON THE INSIDE OF THE DRAWER
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware content s lis t.
If any part is missing or damaged, do not attempt to assemble the produc t.
Estimated Assembly Time: 15 minutes.
Tools Required for Assembly (included): All en Key
AND TAKE OUT LEG S AND HA RDWARE
IN THE PICTURE
The legs and hardware are located under the drawer
BOTTOM PANEL HOLE AS SHOWN AND TIGHTEN WITH
STEP 4 PLACE THE MARBLE (C) GENTLY AS SHOWN.
Loading...