Ivy Bronx W001868907 Installation & Assembly

Assembly Instructions

① Bolt (M6*20MM)

Flat Head

9

② Bolt (M6*20MM)

Round Head

9

Caution: You must read this before you proceed

Table

Parts List

Label Picture Description QTY

A Leg 2

B Table Top 1

Hardware

Label Picture Description QTY

③ Washer 9

④ Allen Key(4MM) 1

⑤ Allen Key(5MM) 1

Page 1 OF 5

Assembly Preparation

Before

Beginning

Assembly

:

*

5 *9 *9

Assembly Steps

Overview

Table Top (B)

Leg (A)

FRONT FACING

This Table has multiple parts and may require up to 30 minutes to assemble.
To give you an overview of the Table parts, the above picture is to help you
put the various parts into perspective. Please read through the instructions
below to familiarise yourself with the parts and steps before assembly.

Page 2 OF 5

Step 1

1.1 1.2

1.4

1.3

Open the carton and place all the parts onto a clean, non-marring surface.
Place the Table Top(B) facedown. 1.1) Insert Leg into Table Top(B).

1.2) Attach Leg(A) to Table Top(B) using Bolts(②) and Washers(③) with
Allen Key(⑤) as shown above.

1.3) Attach Leg(A) to Table Top(B) using Bolts(⑥) with Allen Key(④) as
pictured.

1.4) Attach Leg(A) to Table Top(B) using Bolts(①) with Allen Key(④) as
shown above.
Do not fully tighten the Bolts.

Page 3 OF 5

Step 2

2.1 2.2

2.4

2.3

2.1) Insert Leg into Table Top(B).

2.2) Attach Leg(A) to Table Top(B) using Bolts(②) and Washers(③) with Allen Key(⑤) as
shown above.

2.3) Attach Leg(A) to Table Top(B) using Bolts(⑥) with Allen Key(④) as pictured.

2.4) Attach Leg(A) to Table Top(B) using Bolts(①) with Allen Key(④) as shown above.
Do not fully tighten the Bolts.

Step 3

Stand the Table up, with assistance from your adult partner.
Exert pressure floorwards, onto the Table with both your hands.
This pressure will help the Legs and Table Top reach full alignment status.
Check for wobbles on a LEVEL surface.
If no wobbles are found proceed to tighten the Bolts in a sequential manner, until evenly
secured.
When tightening the Bolts tighten sequentially.
Do not tighten any Bolt fully and then move on towards the next one.
If there are still wobbles, loosen the Bolts and excute the same above process.
If the Table is not Stable it could lead to damage to the product.
Your Table is ready for use.
This Table can only be used on a flat, level surface.

Page 4 OF 5
Page 5 OF 5