Ivy Bronx W001650530 Owner Manual (Ottoman)

Caution : You must read this before you proceed

Ottoman

Label Picture Description QTY

A Seat Panel 1

B Leg 2

C Seat Cushion 1

Label Picture Description QTY

① Bolt (M6*30MM) 5

②

Bolt (M6*25MM) 5

③

Before

Beginnin

g

Assembly

:

Allen Key 1

*5

*5

Overview

Seat Cushion(C)

Seat PanelA)

Leg(B)

FRONT FACING

This Ottoman has multiple parts and may require up to some 30minutes to assemble.To
give you an overview of the Ottoman parts, the above picture is to help you put thevarious
parts into perspective. Please read through the instructions below to familiariseyourself
with the parts and steps before assembly.

Step 1

Step 1.1

Open the carton and place all the parts onto a clean, non-marring surface.

Step 1.1 Insert Seat Panel((A) to Leg(B) as shown above
Step 1.2 Attach Seat Panel((A) to Leg(B) using Bolts(①) with Allen Key(③) as shown

above.
Step 1.3 Attach Seat Panel((A) to Leg(B) using Bolts(②) with Allen Key(③) as shown
above.

Step 1.2

Step 1.3

Step 2

Step 2.1

Step 1.1 Insert Seat Panel((A) to Leg(B) as shown above
Step 1.2 Attach Seat Panel((A) to Leg(B) using Bolts(①) with Allen Key(③) as shown
above.
Step 1.3 Attach Seat Panel((A) to Leg(B) using Bolts(②) with Allen Key(③) as shown
above.

Do not fully tighten the Bolts.

Step 2.2

Step 2.3

Step 3

Then, with the assistance from an adult partner, stand the Chair upright.Adjust the Pre­installed Levellers until the Ottoman is level with the ground.To adjust the Levellers, with
the assistance from an adult partner, tilt the Chair to rest ontwo feet.Adjust the levellers to
the desired height to avoid wobbles.

Step 4

C

Place the Seat Cushion(U) on the ottoman.
Your Ottoman is ready for use.

This Ottoman can only be used on a flat, level surface.