Page 1
ASSEMBLY INSTRUCTIONS
Carefully unpack all lamp parts from the carton.
1. Take the lamp carefully out of the Carton,and place it on a flat surface.
2. Be sure the power to the installation point is power off.
3. Fasten the Crossbar to the Canopy. Thread Mounting Ball to secure it. Hand tighten until snug.
4. Determine the number of Rods to be assembled according to your hanging height. Pass supply wires through the Rods.
Thread the Rods to connect the Swivel and Nipple of the Fixture Body . Hand tighten until sung.
5.Pass the supply wires through the Swivel and Canopy and the hole in the middle of the Cross Bar.
6. The power supply wire consists of three wires, one black wire, one white wire and one silver ground wire.
Connect the wires as shown.A. Connect the House Ground Wire to the Fixture Ground Wire.
B.Connect the House White (or Ribbed) Wire to the Fixture Supply Wire (White or Ribbed Side).
C.Connect the House Black (or Red) Wire to the Fixture Supply Wire (Black or Smooth Side).
D.Wrap each connected wire with Wire Connector and carefully stuff all of the connected wires into the Outlet Box.
7. Install the correct Edison Bulb (Included）onto the Socket referring to fixture markings and/or labels for maximum wattage.
Your installation is completed now. Restore electricity.
Loading...