Page 1
STEP 1
Take out Assembly Instruction sheet, Hardware Pack and
Feet Packaging from the Drawer which marked with the rope.
AI
"BR" & "BL" Marking
at bottom of the Unit
& top of the Leg
"FR" & "FL" Marking
at bottom of the Unit
& top of the Leg
H
I
G
E
C
D
J
STEP 2
Align & fasten feet (B),(C),(D) and (E) to Unit according to the position left and right follow the label correctly using
bolt (G), lock washer (H) and flat washer (I) and fully tighten with Allen Key (J). Align and tighten Support Leg (F)
with leveler to bottom panel of unit (A) by turning center feet with leveler clockwise until tight.
F
Support Leg
1
F
B
A
A
H
I
G
J
NO HARDWARE LIST
C
B
Front Right Feet
1
E
D
Front Left Feet
NO PARTS LIST
Rear Right Feet
Rear Left Feet
1
1
1
A
Dresser
1
REVISION : A
FR
FL
BR
BL
G
Allen Key M4
JCBC M6 x 35mm
SpringWasher
Washer Ø
1
4
" x 20mm
H
I
J
8
8
8
1
ASSEMBLY INSTRUCTIONS
Page 2
ANTI TIPPING
A. DRESSER 1 SET
PARTS IDENTIFICATION
16mm Screw
50mm Screw
Tie Strap
L Bracket
1.
HARDWARE IDENTIFICATION
2.
3.
4.
1 Pc
1 Pc
1 Pc
2 Pcs
Step 3: Place the dresser into position so both mounting brackets are vertically in line. Lace the end of the restraint strap through the
bigger hole on each bracket. Bring both ends together and slide the flat end through the locking end and draw it through until all slack
is removed. Please make sure that the strap is securely laced and locked.
This anti-tipping kit must be attached to a wall using the
provided 50mm screws.
Step 2: Attached the second bracket securely to the wall using the
provided longer 50mm screw, through the smaller hole of the
bracket. Please attach the second bracket to the wall 2 inches
lower than the first bracket that was attached to the back of the
dresser.
1
4
A
Step 1: Attach the bracket securely to the back top rail of the
dresser using the provided smaller 16mm screw, through the
smaller hole of the bracket.
2
Mur
Wall
4
4
3
4
Mur
Wall
Loading...