Page 1
For the hardware, you should have received:
1. Fitted nut
2. Serrated tub
3. Half threaded bolt with a hexagon head
Steps:
1. Placed the fitted nuts with the coned end down onto the serrated end of the serrated tub and push it down into
the tub. Image (a) to (b)
2. Predrill holes in the studs of the wall aligned with the predrilled holes found on the back side of the vanity and
fit the serrated tub with the fitted nut into the studs
3. Thread the bolt through the predrilled hole on the back side of the vanity and into the serrated tub. Image (c)
4. Tighten the bolt with a wrench to secure vanity against the wall.
(a) (b) (c)
Option:
1. As an alternative to the hardware provided, you can purchase a 3” lag screws from a convenience store
2. Predrill holes into the studs of the wall at a thinner gauge than the lag screw, aligned with vanity
3. Drill screw through the vanity into the pre-drilled holes
Vanity Mounting Installation
Instructions
Loading...