Page 1
Label Picture Description QTY
A Table Top 1
B Leg 4
Label Picture Description QTY
① Bolt (M6*18MM) 17
② Washer 17
③ Allen Key 1
Caution: You must read this before you proceed
TABLE
Page 1 OF 4
Page 2
Before Beginning Assembly:
Overview
This Table has multiple parts and may require up to 30 minutes to
assemble. To give you an overview of the Table parts, the above picture is
to help you put the various parts into perspective. Please read through the
instructions below to familiarise yourself with the parts and steps before
assembly.
FRONT FACING
Table Top Panel (A)
Leg (B)
Page 2 OF 4
Page 3
Step 2
Place the Table on a LEVEL SURFACE to check for wobbles.
If it wobbles, apply even steady pressure down on the Table.
This action should help align all parts.
Then proceed to tighten all Bolts at all joints
Do NOT fully tighten a Bolt in one go and then move on to the next one.
Rather, in a sequential manner, gradually tighten each Bolt until all Bolts are
evenly secured.
This methodology will ensure maximum evenness once all Bolts are fully
tightened.
Your Table is ready for use.
This Table can only be used on a flat, level surface.
Step 1
Place the Table Top(A) facedown on a clean non-marring surface.
Attach Leg(B) to Table Top(A) using Bolts(①) and Washers(②) with Allen Key(③) as
shown above.
Repeat the same process to install the remaining three Legs(B).
Do not fully tighten the Bolts.
Page 3 OF 4
Page 4
Page 4 OF 4
Loading...