Page 1
ASSEMBLY INSTRUCTIONS
Chair
ASSEMBLY 1-Person
REQUIREMENTS Assembly (Approximate)
Thank you for purchasing our product!
Please refer and use this assembly instruction to assemble the
product. Contact our customer service department in case there
are any missing or damage parts or hardware.
We appreciate your business!
ASSEMBLY PREPARATION
1. Remove all packaging materials, staples and packing straps from the carton.
2. Refer to Parts List and Hardware List, and ensure parts and hardware are complete before assembly.
Contact customer service for missing parts.
3. Place all wooden parts on a clean, flat and soft surface (e.g. carpet or rug) to prevent parts from getting scratched.
SAFETY PRECAUTION
1. KEEP ALL HARDWARE PARTS OUT OF REACH OF CHILDREN.
2. DISPOSE PLASTIC PACKAGING MATERIAL IMMEDIATELY TO AVOID ANY RISK OF SUFFOCATION TO
CHILDREN AND ANIMALS.
TIPS FOR ASSEMBLY
1. Allow ample room for assembly and in close proximity to where product will be placed.
2. Assemble the product on a surface that does not scratch or damage the exterior gloss and finish of the furniture.
3. Identify all of the parts, hardware and quantities required for each step.
4. During assembly, do not over-tighten any fittings as this may cause damage.
5. DO NOT USE POWER TOOLS TO ASSEMBLE THIS PRODUCT.
6. Always place the product on a flat, level surface.
7. Do not sit or stand on the partially assembled product; only use the product for which it is intended.
CARE AND MAINTENANCE
Use a slightly damp cloth to clean the product. Do not use bleach or abrasive cleaning material.
Check all the fittings periodically and re-tighten as necessary. Do not use the product if any of the parts is
damaged or broken.
Never allow any kind of liquid to remain on your furniture. Absorption can cause wood to warp or delaminate.
Do not place hot items (e.g. hot drinks) directly onto the wood surface.
Do not drag and/or pull the furniture.
This product is for indoor and household use only - not for commercial use.
Page 1 of 2
Assembly Time 30
Minutes
MADE IN CHINA
Page 2
Parts List
Item Part
ASSEMBLY INSTRUCTIONS
Chair
Description
Qty
Item Part
Description
Qty
A
Chair
Leg
4
B
Step 1
Lay Chair Body (E) as shown on a material that
does not scratch the part.
Allen Wrench
1 E
Step 2
C
D
Flat Washer 16
Screw 16
Chair
Body
a) Align screw holes on base plate of each
Chair Leg (A) to respective screw holes at
the corner on bottom of Chair Body (E).
Note: Each leg should angle outwards.
b) Use Allen Wrench (B) to drive Screw (D)
fitted with Flat Washer (C) to fasten (A).
1
Step 3
Set the chair right-side up.
The assembly of the chair is complete.
Page 2 of 2
Loading...