Page 1
Caution : You should read this carefully before you proceed
Table
Label Picture Description
A Leg
B Table Top
C Top Side Bar
D
Middle Support
Bar
QTY
2
2
2
1
Page 2
E Side Support Bar
Label Picture Description
①
Bolt (M6*20MM)
Flat Head
②
Allen Key
Before
Beginning
Assembly:
Overview
FRONT FACING
Side Support Bar（E）
Top Side Bar（C）
2
QTY
29
1
Table Top（B）
Leg（A）
*29
Middle Support Bar（D）
Page 3
This Table has multiple parts and may require up to 30 minutes to assemble. To give you
an overview of the Table parts, the above picture is provided to help you put the various
parts into perspective. Please read through the instructions below to familiarise yourself
with the parts and steps before assembly.
Step 1
Open the carton and place all the parts onto a clean, non-marring surface.
Attach the Middle Support Bar(D) between the 2 Top Side Bars(D) with Bolts(①), using the Allen Key(②)
as shown above.
Do not fully tighten Bolts.
Step 2
Insert the Legs(A)into the sides of the Top Side Bars(C).
Attach the Legs(A) to the Top Side Bars(C)with Bolts(①), using the Allen Key(②)as shown above.
Do not fully tighten Bolts.
D
C
②
①
①
②
A
C
①
), using the Allen Key(②)
②
)as shown above.
A
Page 4
Step3
Connect the legs (A) with the two top support rods (C) with bolts (1), and use the Allen
Key(②)to completely tighten the bolts,as shown above.
Step4
Use bolts (1) on both sides of the support rods (E) connected between the two top support
rods (C), use the Allen Key (2) to completely tighten the bolts, as shown above.
②
①
E
①
②
CCACAEC
Page 5
Step5
Stand up the table,check stability and then tighten all Bolts at all joints.
Note:DO NOT fully tighten a BOLT in one go and then move on to the next. Rather in a
sequential manner, gradually tighten each Bolt until all Bolts are evenly secured.This
methodology will ensure maximum evenness once all Bolts are fully tightened.
Step6
Adjust the Legs' Pre-installed Levelers until the Table is level. To
adjust the Levelers, tilt the Table to rest on 2 legs with assistance from your adult partner.
Adjust the levelers to the desired height to avoid wobbles.
Adjust high for
balance
Adjust low for
balance
Page 6
Step7
Carefully place the Glass Table Tops (B) on the assembled Table Frame.
The Table and its Parts are Heavy.Two adults are required for lifting and moving them.
Step8
B
B
Loading...