Page 1
INSTALLATION INSTRUCTION
MOUNTING THE FIXTURE (FIG. 1)
junction box and test the fixture.
Fig.2
Fig.1
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
1. Shut off the power supply at the fuse box or circuit
breaker. If necessary, remove the old fixture from wall.
Including the mounting hardware.
2. Carefully remove the new fixture from the carton and
check that all parts are included as shown in the
illustration.
3. Attach the mounting plate (M) to the outlet box using
the outlet box screws (K). The side of the mounting
plate marked “GND” must face out.
4. Follow the wiring instructions carefully (See Fig.2).
5. Attach the fixture body (N) over the cross bar (M) by
protruding the mounting screws (L) through the
mounting holes on the fixture body (N) and securing
with ball nut (I) tightly.
6. Install the bulb (not included) in accordance with
fixture’s specifications.
MAXIMUM WATTAGE RATING!) (NE PAS
(DO NOT EXCEED THE
DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!).
7. Thread the stem(G) into coupling(H). After that, install
the steel panel(D), rubber panel(E), glass
panel(F),rubber panel(E), steel panel(D). hex nut(C)
and cover(B) accordingly, and then secure with finial(A)
tightly.
8. If you want to change the fabric shade(O), you need to
remove the screws(P) and take off the shade(O); then
install a new one by securing with the screws(P) as
shown in the Fig.1..
CONNECTING THE WIRES (FIG. 2)
1. At this point, connect the electrical wires as shown in
Fig. 2, making sure that all wire connectors are
secured. If your outlet box has a ground wire (green or
bare copper), connect the fixture’s ground wire to it.
Otherwise, connect the fixture’s ground wire directly to
the mounting strap using the green screw provided.
2. Tuck the wire connections neatly into the wall outlet
box.
Your installation is now complete. Return power to the
-Crossbar
-Ground Screw
-Mounting screws (2)
Loading...