Page 1
INSTALLATION INSTRUCTION
MOUNTING THE FIXTURE (FIG. 1)
emove the old fixture from wall.
or bare copper), connect the fixture’s ground wire to it.
junction box and test the fixture.
Fig.2
Fig.1
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Mounting plate * 1
Mounting screw * 2
Ground screw * 1
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
1. Shut off the power supply at the fuse box or circuit
breaker. If necessary, r
Including the mounting hardware.
2. Carefully remove the new fixture from the carton and
check that all parts are included as shown in the
illustration.
3. Attach the mounting plate (E) to the outlet box using
the outlet box screws (F). The side of the mounting
plate marked “GND” must face out.
4. Follow the wiring instructions carefully (See Fig.2).
5. Attach the fixture wall plate (G) over the mounting
plate (E) by protruding the mounting screws (H)
through the mounting holes on the wall plate (G) and
securing with ball nut (D) tightly.
6. Install the glass shade (B) over the socket (C) and
secure with socket ring (A).
7. Install the bulb (included) in accordance with fixture’s
specifications.
(DO NOT EXCEED THE
MAXIMUM WATTAGE RATING!) (NE PAS
DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!).
CONNECTING THE WIRES (FIG. 2)
1. At this point, connect the electrical wires as shown
in Fig. 2, making sure that all wire connectors are
secured. If your outlet box has a ground wire (green
Otherwise, connect the fixture’s ground wire directly to
the mounting strap using the green screw provided.
2. Tuck the wire connections neatly into the wall outlet
box.
Your installation is now complete. Return power to the
Loading...