Page 1
1
1
CERTIFICATION: UL DRY
INSTALLATION INSTRUCTIONS
IMPORTANT
Before assembling your fixture, please make sure thatyou carefully read
through these instruction sheets. Consider having your fixture installed by
a qualified licensed electrician.
NOTE: The important safeguards and instructions that appear in this
manual are not meant to cover all possible conditions and situations
that may occur. It must be understood that common sense, caution and
care, are factors that can’t be built into any product. These factors must
be supplied by the person(s) caring for and operating the fixture.
GENERAL INFORMATION
All electrical connections must be in accordance with all ordinances,
Local and National Electrical Codes. These fixtures are intended for
mounting to a standard 4” x 2 1/2”metal octagon outlet box. The box
must be directly supported by the building structure and U.L. Recognized.
STEP BY STEP INSTRUCTIONS
Before starting your installation disconnect the Power by turning off the
Circuit Breaker or by removing the fuse at the fuse box. Just turning the
light off at the light switch is not sufficient to prevent electrical shock.
WHAT WE PROVIDE
Mounting Hardware
•
• Crossbar Plate
• Allen wrench
• 5 x Glass shade
• LED
PREPARE FIXTURE
If there is an existing fixture remove it.
Tighten 3pcs x 2sets rods to the canopy and fixture.
APPLICATION
Pendant Fixture
WHAT YOU NEED
Screwdriver
•
• Wire Cutters
• Wiring Supplies as Specified
by Electrical Code
Expose the supply wires from the outlet box.
Page 2
2
4
2
CERTIFICATION: UL DRY
3
MAKE WIRE CONNECTIONS
Gently pull the supply wires through the hole in the
crossbar. Connect the black supply wire to the black
fixture wire. Secure with the supplied wire nuts.
Connect the white supply wire to the white fixture
wire. Secure with the supplied wire nuts. Either
wrap the green wire around one of the protruding
screws or connect it to the supply ground wire.
Secure all wires with electrical tape (not supplied).
Tuck all wires carefully into the J-Box.
Align the centre hole of the canopy and secure with
the supplied screw knob.
INSTALL THE GLASS SHADES
Install the glass shades over the LED module and
secure with the suppled allen screws.
WARNING: DO NOT RESTORE ELECTRICITY
AND USE THIS FIXTURE BEFORE THE GLASS
SHADE IS INSTALLED
RESTORE THE ELECTRICITY AND
CHECK THE OPERATION OF YOUR
If the fixture is to be removed or replaced,
please ensure that the electricity is
CAUTION
switched off and that the fitting is cool
before touching it.
Loading...