4LT VANITY LIGHT ORB
ASSEMBLY / INSTALLATION INSTRUCTIONS
Please read carefull y and save these instruction s , as you may need them at a later date.
CAUTION
Turn off the main power at the circuit breaker before ins talling the fixture, in order to prevent possible shoc k .
GENERAL
All electrical conn ections must be in accordance with local and National Elect rical Code (N.E.C.) st andards.
If you are unfamiliar with proper electrical wiring connections obtain the servi ces of a qualified
electrician. Remove the fixture and the mounting package from the box and make sure that no
parts are missing by referencing the illustrations on the installation instructions. Tools are
required when install this fixture.
REQUIRED TOOLS
Philips screwdriver
ASSEMBLY AND INSTALLATION
Turn off the power at fuse or circuit breaker
1. Carefully unpack the fixture; lay out all parts on a clean surface.
2. Fasten the MOUNTING RING onto the OUTLET BOX by using 2 OUTLET BOX SCREWS provided.
3. Tie ground wire from OUTLET BOX and from fixture to the GROUND SCREW on the MOUNTING RING.
Connect white wire from fixture to white wire (neutral wire) from supply circuit. Connect black wire from
fixture to black wire (live wire) from supply circuit. Cover connections us i ng provided WIRE CONNECTORS.
4. Place the WALL PLATE over the MOUNTING RING, and tighten the 2 MOUNTNG SCREWS
on the top and bottom of the WALL PLATE.
5. Install the BULBS (included).
6. Screw the SHADES onto the SOCKETS until tightened.
Turn on the power at fuse or circuit breaker.
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN.
Loading...