MOUNTING THE FIXTURE (FIG. 1)
emove the old fixture from wall.
by protruding the mounting screws (A) through the
or bare copper), connect the fixture’s ground wire to it.
irectly to
junction box and test the fixture.
Fig.2
Fig.1
AVER TI SSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Mounting plate * 1
Mount
Ground screw * 1
L
J
M
H
I
D
E
G
F
INSTALLATION INSTRUCTION FOR FIXTURE
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
1. Shut off the power supply at the fuse box or circuit
breaker. If necessary, r
Including the mounting hardware.
2. Carefully remove the new fixture from the carton and
check that all parts are included as shown in the
illustration.
3. Determine the rod length if necessary, then assemble
the rods (H) together tightly, then assemble small loop
(F) onto the top end of the rods (H) and assemble the
bottom end of the rods (H) into the coupling (I).
4. Connect both small loops (F) together using small
hook (G) well.
5. Attach the mounting plate (C) to the outlet box using
the outlet box screws (B). The side of the mounting
plate marked “GND” must face out.
6. Follow the wiring instructions carefully (See Fig.2).
7. Attach the fixture canopy (D) over the mounting plate
(C)
mounting holes on the canopy (D) and securing with
ball nut (e) tightly.
8. Put the glass shade (L) over the socket (M) and
secure with socket ring (J).
9. Install the bulb (included) in accordance with fixture’s
specifications.
(DO NOT EXCEED THE
MAXIMUM WATTAGE RATING!) (NE PAS
DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!).
CONNECTING THE WIRES (FIG. 2)
1. At this point, connect the electrical wires as shown
in Fig. 2, making sure that all wire connectors are
secured. If your outlet box has a ground wire (green
6”L ROD
12L.ROD
ing screw * 2
Otherwise, connect the fixture’s ground wire d
the mounting strap using the green screw provided.
2. Tuck the wire connections neatly into the wall outlet
box.
Your installation is now complete. Return power to the
Loading...