V1.0
IR-650636-F60 IR Camera Function Description:
5
4
6
185 mm
8
11
1 2
3
7
9 10
IR-650636-F60 IR Bullet Outdoor Camera Function Description:
1.) IR LED: There are 36 pcsψ5 IR LED which will be turned on when the light is lower than 0.5 Lux.
2.) Lens: 6 mm IR Lens. Provide 4mm/8mm as alternative choice.
3.) Fix Hole: There are 4 holes to fix wall mount bracket.
4.) Sunshade Cover: To prevent the sunshine to camera directly.
5.) Vertical Screw: To adjust the vertical position of camera.
6.) Wall Mount Bracket: To fix camera on the wall and store cable inside the bracket.
7.) Horizontal Screw: To adjust the horizontal position of camera.
8.) Cabling Outlet: To connect the outside cable via these holes.
9.) LED: Power indicator, Green LED On: Power on. Green LED Off: No Power. Yellow LED: Reserve
10.) RJ-45 connectors: To transmit Power and Video signals via UTP cable. Please refer to the RJ45 pin assignment.
Socket cable: To Connect OSD control cable (Optional) for camera parameters setup.
11.)
PRX-120VP Function Description: (On DVR site)
Front Panel
PRX-120VP Back Panel
RJ-45 Connector Pins Assignment
1 2
3
4
5
1.) RJ-45 connector: To transmit Power and Video signals via UTP cable. Please refer to the pin assignment.
2.) LED: Power indicator, LED On: Power on. LED Off: Not enough power or No Power.
3.) BNC Cable: For video output to DVR.
4.) Terminal Blocks: Power input for power transmission. Accept power range DC 24V or AC 24V-28V.
5.) RJ-45 pin Assignment: Connect the 4-pair UTP cable between DVR site and camera end for video/power transmission.
1
Installation Notes:
1. Please use point-to-point Unshielded Twisted Pair wire, 24-16 AWG, Category 2, 3, 4, 5, or 6.
2. Please measure the wire distance, Use only transceivers that are designed for that distance.
3. Please make sure the pair of wires carrying the video signal is sent as a twisted pair (e.g. the Blue-white/White-blue
wires twisted together as a pair), not a “split-pair” (e.g. blue-white conductor, part of one pair / orange-white conductor,
part of another pair).
Installation Warning:
1. Please DO NOT USE SHIELD TWISTED PAIR WIRE. This will cause severe degradation on distance performance and
reduce the inherent interference immunity.
2. Please DO NOT have “bridge-taps” or loading coils in installation.
3. If the phone company provides the cable runs between buildings, make sure it’s “dry copper”.
4. Due to near-end cross talk, don’t send a transmitted and a received signal in the same wire bundle. For safety, DO
NOT put UTP cable in the same conduit as high-voltage wiring.
Specification:
Item Model
Image Device 1/3“ SONY EXview HAD CCD II (Effio-E)
Effective Picture Elements PAL: 1024(H)x596 (V); NTSC: 1028(H)x508(V)
Horizontal Resolution Color: 650TVL; B/W: 700TVL
Minimum Illumination Color: 0.03Lux@F1.0, B/W: 0 Lux (IR LED on)
Wide Dynamic Range ATR Digital WD (ATR: Adaptive Tone-curve Reproduction)
S/N Ratio More than 50dB (AGC Off)
IR-650636-F60 (40/80/120)
Shutter Speed Control AUTO (1/50(60) ~ 1/100,000 sec.)
Lens 6 mm / F2.0 (optional: 4mm/8mm/120mm)
Video Output RJ-45 connector; BNC composite connector (Option)
Gain Control Auto (4 steps)
White Balance ATW / PUSH / USER define / ANTI CR / MANUAL / PUSH LOCK
Back Light Compensation HLC / BLC / OFF
Gamma Characteristic 0.45
Day/Night Mode Color / B&W / AUTO / Ext.
Control Parameters Menu OSD (With an optional OSD cable control)
Flicker Less ON/OFF
Dynamic Noise Reduction 2D
Motion Detection ON / OFF (24x16 Zones)
Privacy Mask ON / OFF (8 programmable mosaic zones)
Video: Peak Inverse Blocking Voltage: VPIB = 100V;
Surge Protector
Waterproof IP 67
Infrared Luminary 36pieces Ø5 IR-LED
Transmission Distance Video / Power up 300 meters (Cat. 5 or above)
Peak Pulse Current: Ipp=44A; Clamping Voltage: 10V @ Ipp= 5A
Power: Max. Energy: 3.6J (@10/1000μ);
Clamping Voltage: 16.8KA(1Time)/8.4KA (2Times) @ 8/20μs (1 Time);
Insulation Resistance: ≧10000MΩ
Power Consumption
Operation Temperature -10°C ~ 50°C; Humidity 20% ~ 80% RH
Dimension/Weight 85 (W) x 185 (H) x 240 (L) mm / 0.8Kg (Including bracket)
DC 24V/140mA max, IR OFF: DC 24V/25mA
2