Ives Offset Intermediate Pivot 7212/12V, Offset Top Pivot 7222, 7212, 7212V, 7222 Installation Instructions Manual

Right hand
installation

Installation Instructions

7212/12V and 7222

3/4” Offset Intermediate Pivot

Door

leaf

Frame

leaf

Bearing

spindle

3/32” Allen

wrench

3/32” set screw

Right hand

installation shown;

left hand opposite

Left hand

installation

5/32” Allen

wrench

1. Prepare and mortise hinge stile of door and hinge side jamb to receive pivot set. Determine
pivot location using dimensions on reverse side. The pivots are handed and must match hand
of door. To determine hand of door and proper pivot position, see diagrams above. Install top
and bottom pivot sets before installing intermediate pivot.

2. Locate, drill, and tap 1/4-20 mounting holes for metal door. Locate and drill pilot holes for
#14 wood screws for wood door. Then hang door.

3. Open door about 90°. Install pivot leafs with 1/4-20 x 3/4” FHMS or #14 FHWS screws provided.

4. The door weight should be balanced between bottom and intermediate pivots. To adjust

intermediate pivot (refer to diagram above):

A. Loosen set screw in jamb leaf with 3/32” Allen wrench.
B. Insert 5/32” Allen wrench through jamb leaf pivot and into underside of bearing spindle.
C. Turn clockwise until door weight is balanced evenly with bottom pivot.
D. Tighten 3/32” set screw securely.

!

CAUTION

Improper pivot set installation can lead to personal injury or property damage. Follow

all instructions carefully. For questions contact Technical Support at 1-888-371-7331.

13103 Rev. 4 © 2006 Ingersoll-Rand Company Limited

!

It is very important for installer to verify that intermediate pivot point lines up with
center line of top and bottom pivot points before final installation. Both door and
frame pivot leafs located from face of door. Intermediate pivot should be evenly
spaced between top and bottom pivots. Heel edge of door must be beveled 1/8” in 2”.

NOTE

Frame Leaf

Face of door

1/2”

13 mm

C

3/4”

19 mm

L

Reference line

5/16”
8 mm

5/16”

8 mm

C

L

5/16”
8 mm

5/16”

8 mm

Right hand installation shown;

left hand opposite

Door Leaf

1/2”
13 mm

C

L

3/4”
19 mm

Face

of door

13103-00

13103 Rev. 4