Ives Heavy Duty Offset Top Pivot 7230F Installation Instructions Manual

Installation Instructions

7230F

3/4” Heavy Duty Offset Bottom Pivot

Right hand

Cap screw

Pivot cap

3/32” set

screw

installation shown;

left hand opposite

Door leaf

Right hand
installation

1. Prepare and mortise bottom of door and floor to receive pivot set. Determine pivot location
using dimensions on reverse side. Be sure to properly locate and mark pivot center point
of the base plate. The bottom pivot set is non-handed. The pivot shaft will thread into either
side of door leaf. To determine hand of door, see diagrams above.

2. Prepare bottom of door: Locate, drill, and tap 1/4-20 mounting holes for metal door. Locate and drill
pilot holes for #14 wood screws for wood door. Mount door leaf in bottom of door with 1/4-20 x 3/4”
FHMS or #14 FHWS screws provided. Drill 7/16” dia. x 3/4” deep holes for base plate mounting.
Insert and secure anchor pins, then mount base plate to floor with screws provided.

3. At this point, hang door. Refer to instruction sheet packed with top pivot for details.

4. If height adjustment is necessary for proper door clearance, adjust bottom pivot as follows:

A. Loosen set screw using 3/32” Allen wrench provided (see diagram above).
B. Use 5/16” Allen wrench to adjust pivot shaft height as needed (Figure 1).
C. Tighten set screw firmly.

Pivot shaft

Base plate

Left hand

installation

Figure 1

5. Fasten pivot cap as shown. Secure with cap screw.

!

Improper pivot set installation can lead to personal injury or property damage. Follow

all instructions carefully. For questions contact Technical Support at 1-888-371-7331.

26362 Rev. 3 © 2006 Ingersoll-Rand Company Limited

CAUTION

!

It is very important for installer to verify that center line of top pivot point lines up
with center line of bottom pivot point before final installation. Heel edge of door
must be beveled 1/8” in 2” as shown below.

NOTE

Depth of mortise will vary

*

depending upon installation
and/or threshold height.

Bevel heel edge

of door 1/8” in 2”

with 3/16” rad, typ

Edge of base

plate is flush with

edge of door

3/4”
19 mm

2-3/8”
60 mm

1-3/16”
30 mm

5/16”
8 mm

13/16”
21 mm

*

to

1-1/4”
32 mm

*

Right hand installation shown;

26362-00

left hand opposite

26362 Rev. 3