Ives 7245F User Manual

Installation Instructions

7244F and 7245F

1-1/2” Intermediate Pivot

Door leaf

installation shown;

left hand opposite

Frame

leaf

Right hand

Right hand
installation

Pivot

cap

1. Prepare and mortise hinge stile of door and hinge side jamb to receive pivot set. Determine
pivot location using dimensions on reverse side. The pivots are handed and must match
hand of door. To determine hand of door and proper pivot position, see diagrams above.
Install top and bottom pivot sets before installing intermediate pivot.

2. Locate, drill, and tap 1/4-20 mounting holes for metal door or metal frame. Locate and drill
pilot holes for #14 wood screws for wood door or wood frame. Then hang door.

3. Open door about 90°. Install pivot leafs with 1/4-20 x 3/4” FHMS or #14 FHWS screws provided.

4. The door weight should be balanced between bottom and intermediate pivots. Refer to

diagram above. To adjust intermediate pivot:

A. Use 5/32” Allen wrench to remove pivot cap from frame leaf.
B. Insert Allen wrench into pivot pin height adjuster.
C. Turn clockwise until pivot pin makes contact with steel ball inside door leaf.
D. Adjust carefully to balance the weight of the door.

Pivot pin height

adjuster

5/32” Allen

wrench

Left hand

installation

5. Re-install pivot cap.

!

Improper pivot set installation can lead to personal injury or property damage. Follow

all instructions carefully. For questions contact Technical Support at 1-888-371-7331.

26366 Rev. 3 © 2006 Ingersoll-Rand Company Limited

CAUTION

!

NOTE

It is very important for installer to verify that center line of intermediate pivot point
lines up with center line of top and bottom pivot points before final installation.
Both door and frame pivot leafs located from face of door. Intermediate pivot
should be evenly spaced between top and bottom pivots. Heel edge of door
must be beveled 1/8” in 2”.

Frame Leaf Door Leaf

9/16”

14 mm

Face of door

C

L

1-1/2”

38 mm

Reference line

7/16”
11 mm

5/16”
8 mm

5/16”

8 mm

3/8”

10 mm

Right hand installation shown;

left hand opposite

1-1/16”
27 mm

Face
of door

C

L

1-1/2”
38 mm

26366-00

26366 Rev. 3