Ives 7212V User Manual

Installation Instructions

7212V 3/4” Offset Jamb Mount Top Pivot

3/32” Allen

wrench

Set

screw

Right hand
installation
shown; left

hand opposite

Right hand
installation

1. Prepare and mortise top of door and side jamb to receive pivot set. Determine pivot location
using dimensions on reverse side. The pivots are handed. To determine hand of door and
proper pivot position, see diagrams above.

2. Locate, drill, and tap 1/4-20 mounting holes for metal door or metal frame. Locate anddrill
pilot holes for #14 wood screws for wood door or wood frame. Install pivot leafs with
1/4-20 x 3/4” FHMS or #14 FHWS screws provided.

Jamb

leaf

Pivot

pin

Door

leaf

Left hand

installation

3. Loosen set screw in pin leaf with 3/32” Allen wrench provided and remove pivot pin.

4. With door in open position (about 90° to jamb), carefully fit door onto bottom pivot at a slight

angle. Tip door into vertical position, aligning top pivot leafs in door and jamb. With pivot
leafs aligned, insert pivot pin into pivot set. Vertically align groove in pivot pin with set

screw in pivot leaf. Tighten set screw securely with 3/32” Allen wrench.

5. To remove door from jamb: Use 3/32” Allen wrench to loosen set screw in door pivot leaf.

Pull pivot pin out of pivots. Door can now be removed from opening.

!

Improper pivot set installation can lead to personal injury or property damage. Follow

all instructions carefully. For questions contact Technical Support at 1-888-371-7331.

31582 Rev. 4 © 2006 Ingersoll-Rand Company Limited

CAUTION

!

NOTE

It is very important for installer to verify that center line of top pivot point lines up
with center line of bottom pivot point before final installation. Heel edge of door
must be beveled 1/8” in 2” as shown below.

5/16”

8 mm

1-1/8”

29 mm

Face of door

5/8”

16 mmJamb Leaf

3/8”
10 mm

9/16”

14 mm

Edge of door

31582-00

1”
25 mm

1-1/8”
29 mm

Door Leaf

3/4”
19 mm

31582 Rev. 4