Ives 7212 User Manual

Installation Instructions

7212

3/4” Offset Jamb Mounted Bottom Pivot

Right hand

Door

leaf

installation shown;

left hand opposite

Bearing

spindle

Jamb

leaf

1. Prepare and mortise bottom of door and side jamb to receive pivot set. Determine pivot
location using dimensions on reverse side. Be sure to properly locate and mark center
point of the jamb leaf spindle. Care must be taken to ensure that jamb leaf is completely
level. Place level against jamb leaf surfaces as shown in Figure 1. The bottom pivot set is
handed. Hand of pivot must match hand of door. To determine hand of door, see diagrams above.

2. Locate, drill, and tap 1/4-20 mounting holes for metal door or metal frame. Locate anddrill
pilot holes for #14 wood screws for wood door or wood frame. Mount jamb leaf to side jamb
and door leaf in bottom of door with 1/4-20 x 3/4” FHMS or #14 FHWS screws provided.

3/32” Allen

wrench

Set

screw

Right hand
installation

Left hand

installation

Figure 1

3. At this point, the top pivot of the set should be installed. After top pivot installation, hang door.
Refer to instruction sheet packed with top pivot for details.

4. If height adjustment is necessary for proper door clearance, adjust bottom pivot as follows:

A. Remove top pivot pin and take door down.
B. Use 3/32” Allen wrench provided to loosen set screw in jamb leaf (see diagam above).
C. Adjust bearing spindle height with 5/8” Allen wrench. Range is plus 1/8”, minus 1/16”.
D. Re-install door.

!

Improper pivot set installation can lead to personal injury or property damage. Follow

all instructions carefully. For questions contact Technical Support at 1-888-371-7331.

16000 Rev. 4 © 2006 Ingersoll-Rand Company Limited

CAUTION

!

It is very important for installer to verify that center line of top pivot point lines up
with center line of bottom pivot point before final installation. Heel edge of door
must be beveled 1/8” in 2” as shown below. The bottom pivot set should be
mounted first in most installations.

NOTE

Depth of mortise will vary

*

depending upon installation
and/or threshold height.

Bevel heel edge of door

1/8” in 2” with 3/16” rad, typ

Door Leaf

Face of door

3/4”

19 mm

3/8”
10 mm

9/16”
14 mm

*

to

15/16”
24 mm

1-1/8”
29 mm

5/16”
8 mm

*

1-3/8”

35 mm

16000-00

3/8”
10 mm

Frame Leaf

16000 Rev. 4