ITT POWERLOCK BOX Operation And Maintenance Manual

POWERLOCK BOX

OPERATION AND MAINTAINENCE GUIDE

BBAI 1328 Issue E

BAS10642

05/02/2013

PART NUMBER BREAKDOWN

Product
Description

PBX

Contact Type

PS

Power Source

PD

Power Drain

Box Type

SL

Sealed Lid

SLF

Sealed lid
With flange

NL

No Lid

Region Colour Code

EU – European

– United States

US
AU – Australia

Maximum Current
Rating

400
660

NLF

No lid
With flange

Part number example: PBX-PD-SL-US-400 is a 400 amp unit with drain contacts and lid,
colour coded for the USA

COLOUR CODING

Region
Europe
United States
Australia

ACKING

UN-P

Ensure the unit is up the correct way before un-packing. The carton and its packing are
recyclable and should be disposed of according to national or local authority guidelines.

Earth Neutral L1 L2 L3

CONTENTS

After un-packing, the part number of the PowerLock Box should be checked against your order
and that on the carton. Also check that the current rating label on the unit matches your
requirements. The carton should contain the following:-

Qty Description
1 PowerLock Box
1 6mm square drive key
1 3 pole cable connector for remote sensing
1 Operating / Maintenance guide

If any parts are missing or the unit’s description does not match, you should contact your
supplier.

MOUNTING INSTRUCTIONS

The unit may be mounted into standard 19’’ rack systems or to dedicated panel mounts within
buildings or remote cabinets. It is recommended that M6 screws / bolts and flat washers are
used, and tightened to a torque of 2.94NM min. to 3.43NM max.

Caution – Tighten screws / bolts evenly and ensure the unit is adequately supported during
mounting.

88.90

(107.00 for
Flange type.)

6.50
MIN

CUT OUT BELOW FOR FLANGE TYPE ONLY.

If fitting to a 19” rack that does not support all IEC 60297 fixing holes it may be necessary to
use additional mounting plates. ITT part number 003-7586-000 available on request.