Itronix Duo-Touch, GoBook, GoBook II Product Support Bulletin

Technical Bulletin

Recommended Method for Placing GoBook and
GoBook II Computers into the GoBook Vehicle Cradle

Introduction

This Technical Bulletin was created to provide a procedure for correct placement of the GoBook and GoBook II computers into the
GoBook vehicle cradle

Fault Condition

Incorrect placement of the computer into the vehicle cradle could damage the cradle pin assembly.

Solution

Following the steps below allow the computer to be properly placed into the vehicle cradle.

Step 1 Step 2 Step 3

Front corner stops

Close all port covers on the back of the
computer. While holding the computer at
a slight angle, place the front bottom
corners of the computer against the front
corner stops of the cradle.

801 South Stevens • P.O. Box 179 • Spokane, WA 99210 • 509.624.6600 • 800.441.1309

Using your hand (or hands) as a guide
along side of the computer and cradle,
rotate the computer down so that it sits
flat on the vehicle cradle. Verify that any
handle attached to the computer is not
obstructing the latching mechanism at
the rear of the vehicle cradle.

Latch

Secure the computer to the vehicle cradle
by pushing in on the latch at the front of
the vehicle cradle. The green light will
illuminate to indicate that the vehicle
cradle is powered on.

97-0092-001 21 February 2003