Itron NIC506 User Manual

eBridge Labeling

Integrator's Guide

Silver Spring Networks

DW_EDIT_SSN - Bridge FCC Labeling 080208.doc

eBridge Labeling
Integrator's Guide

1 Introduction

The Silver Spring Networks eBridge is a FCC Part 15.247 compliant device that enables
communication between Silver Spring Networks AMI network and intelligent endpoint device
(IED) connected to either the serial or Ethernet port of the eBridge. The eBridge transmits in
the 902 to 928 MHz, ISM band and transfers data from the IEDs to Silver Spring Networks Access
Points, Relays and/or other continuous power device acting as network relays.

2 eBridge Labeling

The SSN eBridge has two labels relevant to unit assembly – the FCC & Part Number label and
the SSN MAC Address label. Both labels are located on the top side of the eBridge PCBA. The
barcode format is Code 3 of 9.

Figure 1 is an example of the FCC ID label that can be found in the location indicated in

Silver Spring Networks

2

eBridge Labeling
Integrator's Guide

Figure 3. The size of the label is 1.5” x 1.0” inches. The barcode format is Code 3 of 9.

Figure 1 – FCC & Part Number Label for eBridge PCBA

SSN PN 123-456789

FCC ID: OWS-NICxxx IC: 5975A-NICxxx

This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
996-000015A

Figure 2 is an example of the MAC address label that can be found in the location indicated in

Silver Spring Networks

3