Itron INTELISG Users Manual
OpenWay® Riva Intelis Gas Meter
Installation Guide
Technical
Communications
knowledge to shape your future
Identification
OpenWay® Riva Intelis Gas Meter Installation Guide
23 May 2018
TDC-1782-000
Copyright
© 2018 Itron, Inc. All rights reserved.
Confidentiality Notice
The information contained herein is proprietary and confidential and is being provided
subject to the condition that (i) it be held in confidence except to the extent required
otherwise by law and (ii) it will be used only for the purposes described herein. Any third
party that is given access to this information shall be similarly bound in writing.
Trademark Notice
Itron is a registered trademark of Itron, Inc.
All other product names and logos in this documentation are used for identification purposes
only and may be trademarks or registered trademarks of their respective companies.
Suggestions
For more information about Itron or Itron products, see www.itron.com.
If you have questions or comments about the software or hardware product, contact Itron
Technical Support Services.
Contact
• Email: support@itron.com
• Internet: support.itron.com
• Telephone Itron Technical Support North America: 1-877-487-6602
For technical support contact information by region, go to www.itron.com and select your
country and language.
Contents
Chapter 1 Important Safety and Compliance Information.............................. 1
USA, FCC Part 15 compliance............................................................................................................................. 1
Canada, ISED compliance.................................................................................................................................... 2
RF Exposure (FCC/ISED)...................................................................................................................................... 2
Electromagnetic compatibility...............................................................................................................................2
Intrinsic safety.......................................................................................................................................................3
Lithium battery...................................................................................................................................................... 3
Transportation classication................................................................................................................................. 3
Electrostatic discharge..........................................................................................................................................3
Electrostatic ignition hazard..................................................................................................................................3
Device cleaning.....................................................................................................................................................4
Do Not Drop .........................................................................................................................................................4
Product notication...............................................................................................................................................5
Chapter 2 The OpenWay® Riva Intelis Gas Meter........................................... 6
OpenWay Riva Intelis Gas Meter models............................................................................................................. 6
Intelis meter components..................................................................................................................................... 6
OpenWay Riva Intelis Gas Meter LCD....................................................................................................... 7
Integrated 500G ERT module.....................................................................................................................8
Internal shut off valve................................................................................................................................. 8
Auto disconnect conguration............................................................................................................9
Intelis meter specications................................................................................................................................... 9
Intelis meter dimensions .................................................................................................................................... 10
Chapter 3 Installing the Intelis Meter.............................................................. 11
Prior to start-up...................................................................................................................................................11
Start-up...............................................................................................................................................................11
The Intelis meter capacity and pressure loss test.............................................................................................. 12
Chapter 4 Proving and Calibrating the Intelis Meter......................................13
Prover types........................................................................................................................................................13
Proving operations..............................................................................................................................................14
Conguring Test Mode.............................................................................................................................14
Entering Test Mode.................................................................................................................................. 14
Recording prover consumption................................................................................................................15
Exiting Test Mode.....................................................................................................................................15
Adjusting the Intelis meter calibration......................................................................................................15
Chapter 5 OpenWay Riva Intelis Gas Meter Maintenance.............................16
OpenWay® Riva Intelis Gas Installation Guide TDC-1782-000 iii
Proprietary and Confidential
Chapter 1 Important Safety and Compliance
Information
This section provides important information for your safety and product compliance.
USA, FCC Part 15 compliance
This device complies with Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
Operation is subject to the following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference that may cause undesirable operation.
This device must be installed to provide a separation distance of at least 20 centimeters (7.9
inches) from all persons to be compliant with regulatory RF exposure.
USA, FCC Class B-Part 15
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio or TV technician for help.
Modifications and Repairs
To ensure system performance, this device and antenna shall not be changed or modified
without the express approval of Itron. Per FCC rules, unapproved modifications or operation
beyond or in conflict with these instructions for use could void the user's authority to operate
the equipment.
OpenWay® Riva Intelis Gas Installation Guide TDC-1782-000 1
Proprietary and Confidential
Important Safety and Compliance Information
Canada, ISED compliance
Compliance Statement Canada Déclaration de Conformité
This device complies with Innovation, Science
and Economic Development Canada (ISED)
license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this
device may not cause interference, (2) this
device must accept any interference, including
interference that may cause undesired operation
of the device.
Under Innovation, Science and Economic
Development Canada (ISED) regulations, this
radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain
approved for the transmitter by Industry Canada.
To reduce potential radio interference to other
users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated
power (e.i.r.p.) is not more than that necessary
for successful communication.
Le présent appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes: (1)
l'appareil ne doit pas produire de brouillage, (2)
l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le
fonctionnement.
Conformément à la réglementation d'Industrie
Canada, le présent émetteur radio peut
fonctionner avec une antenne d'un type et d'un
gain maximal (ou inférieur) approuvé pour
l'émetteur par Industrie Canada. Dans le but de
réduire les risques de brouillage radioélectrique à
l'intention des autres utilisateurs, il faut choisir le
type d'antenne et son gain de sorte que la
puissance isotrope rayonnée équivalente (p.i.r.e.)
ne dépasse pas l'intensité nécessaire à
l'établissement d'une communication
satisfaisante.
RF Exposure (FCC/ISED)
This equipment complies with radiation exposure
limits set forth for an uncontrolled environment.
This equipment should be installed and operated
with minimum distance 20 cm between the
radiator and your body. This transmitter must not
be co-located or operating in conjunction with
any other antenna or transmitter.
Cet équipement est conforme aux limites
d'exposition aux radiations dans un
environnement non contrôlé. Cet équipement do
it être installé et utilisé à distance minimum de 20
cm entre le radiateur et votre corps. Cet émetteur
ne doit pas être co-localisées ou opérant en
conjonction avec tout autre antenne ou
transmetteur.
Electromagnetic compatibility
Caution
high quality, shielded, and correctly terminated. Unapproved modifications or
operation beyond or in conflict with these use instructions may void the authority's
authorization to operate the equipment.
: Use only approved accessories with this equipment. All cables must be
OpenWay® Riva Intelis Gas Installation Guide TDC-1782-000 2
Proprietary and Confidential
Intrinsic safety
Warning: Substitution of components may impair intrinsic safety.
Lithium battery
Warning: Follow these procedures to avoid injury to yourself or others.
• The lithium battery may cause a fire or chemical burn if it is not disposed of
properly.
• Do not recharge, disassemble, heat above 100°C Celsius (212°Fahrenheit),
crush, expose to water, or incinerate the lithium battery. Fire, explosion, and
severe burn hazard.
• The battery used in this device may present a risk of fire or chemical burn if
mistreated.
• Keep the lithium battery away from children.
• Batteries must not be replaced or modified in any way.
Important Safety and Compliance Information
Transportation classification
The Federal Aviation Administration prohibits operating transmitters and receivers on all
commercial aircraft. When powered, the Itron device is considered an operating transmitter
and receiver and cannot be shipped by air. All product returns must be shipped by ground
transportation.
Electrostatic discharge
Warning
Before installation, discharge electrostatic buildup by touching a metal pipe or other
earth-grounded metal object prior to touching the meter body, register housing, or
Itron device.
: Internal circuit components can be sensitive to electrostatic discharge.
Electrostatic ignition hazard
Warning
touching the Itron device.
: Verify the area is not hazardous when installing, servicing, cleaning, or
OpenWay® Riva Intelis Gas Installation Guide TDC-1782-000 3
Proprietary and Confidential
Loading...