ENG-
Page 1 of 3
Integration Spec
TITLE: HHSR3 Integration requirements spec
AUTHOR: Drew Rosenberg
REV CCO
DESCRIPTION OF CHANGE DATE AUTHOR
REVISION HISTORY
Information contained herein is proprietary and is property of ITRON, Inc. where furnished with a proposal, the recipient shall use it
solely to evaluate the proposal. Where furnished to a customer it shall be used solely for the purposes of inspection, installation, or
maintenance. Where furnished to a supplier, it shall be used solely in the performance of work contracted for this company. The
information shall not be used or disclosed by the recipient for any other purpose whatsoever.
NOTICE OF PROPRIETARY INFORMATION
ITRON CONFIDENTIAL
Integration Spec ENG-
Table of Contents HHSR3 Integration requirements spec Table of Contents
1. Table of Contents
1.
TABLE OF CONTENTS ........................................................................................................... 2
2. SCOPE OF THIS DOCUMENT ................................................................................................ 3
3. TECHNICAL REQUIREMENTS ............................................................................................... 3
4. LABELING REQUIREMENTS ................................................................................................. 3
5. USERS MANUAL STATEMENTS ........................................................................................... 3
Page 2 of 3 Rev. A
Integration Spec ENG-
Scope of this Document HHSR3 Integration requirements spec Users Manual Statements
2. Scope of this Document
This document lists everything that is required for maintaining the conditions of the limited
modular approval that applies to the HHSR3 module (FCC ID EO9HHSR3, IC ID 864A-HHSR3).
3. Technical Requirements
This module may only be installed in battery-powered devices. Uses that require power from line
voltage are not allowed under the conditions of this limited modular approval.
4. Labeling Requirements
The label on the final product must say the following:
Contains
FCC ID: EO9HHSR3
IC: 864A-HHSR3
5. Users Manual Statements
The following statements must be included in the users manual:
ELECTROMAGNETIC COMPATIBILITY
Use only approved accessories with this equipment. Unapproved
modifications or operation beyond or in conflict with these instructions for
use, may void authorization by the authorities to operate the equipment.
This device has been designed to operate with the antennas listed
below, and having a maximum gain of 2.1 dB. Antennas not included in
this list or having a gain greater than 2.1 dB are strictly prohibited for use
with this device. The required antenna impedance is 50-ohms. To reduce
potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that permitted for successful communication.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
RF EXPOSURE
To comply with the FCC requirements, maintain a separation distance of
at least 20.0 centimetres between the antenna and all persons.
Page 3 of 3 Rev. A
Loading...