i-Key 4 TX Quick Reference Guide
Compliance
i-Key products are compliant with the following organizations
INTRODUCTION
The i-Key 4 TX is a long range access control transmitter that behaves exactly
like a proximity card, but with range of up to 25 metres. i-Key 4 has 4
buttons, allowing many functions to be controlled by the one pendant.
Additionally, the TX can be supplied with a micro disc inside which acts as a
proximity card allowing long range access to roller shutters via the
pushbuttons and regular door access by presenting the pendant to a regular
access control reader.
BUTTONS i-Key TX Pendant
The diagram details the pendant button layout.
BATTERY REPLACEMENT
To replace the batteries on the i-Key 4 TX simply
unscrew the two screws at the top and bottom on
the rear of the pendant. The keyring does not
have to be removed. Replace the battery with a
CR2032 battery and ensure the polarity is correct.
Always check the seal is in place before
reassembly.
LED (illuminates when a
button is pressed)
SPECIFICATIONS
Dimensions: 36mm (W) x 16mm (D) x 56mm (H)
Power: CR2032 lithium battery
ORDERING CODES
i-Key 4 TX 4 button Transmitter
i-Key 4 TX/EM 4 button Transmitter with EM disc
i-Key 4 TX/H 4 button Transmitter with HID Proximity disc
i-Key 4 TX/IC 4 button Transmitter with HID i-Class disc
i-Key 4 TX/IN 4 button Transmitter with Indala disc
i-Key 4 TX/K 4 button Transmitter with Keri disc
i-Key 4 TX/M 4 button Transmitter with Mifare disc
i-Key 4 TX/TC 4 button Transmitter with Tecom disc
DIMENSIONS
36mm
56mm
16mm
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one of the following measures:
. Reorient or relocate the receiving antenna.
. Increase the separation between the equipment and receiver.
. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
. Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment. (Example - use only shielded interface cables when connecting to computer or
peripheral devices).
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may
cause undesired operation.
Loading...